Question about Hyundai Cars & Trucks

Open Question

2007 Santa Fe. I have an Eclipse AVN 62 d car CD/stereo system. The ESN is locked. Is there any way to reset it without the CD used to set it up?

Posted by Shaleen Baldino on

Ad

5 Related Answers

kakee

Michael Galve

  • 1269 Answers

SOURCE: HOW TO YOU GET AT PRESSURE SENSOR ON COMMON RAIL HYUNDAI SANTA FE 2007 CDX

This is what it looks like

47cf2f5.jpg

Posted on Oct 28, 2008


Anonymous

  • 566 Answers

SOURCE: 2007 Hyundai Santa Fe - Replacing fog light

hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?

Posted on Oct 28, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: 2003 hyundai santa fe car alarm

I had the same problem a while back. What I did was disconnect the battery for a minute and I havent had that problem since.

Posted on Feb 14, 2009

Anonymous

  • 57 Answers

SOURCE: need instructions on removing hyundai santa fe 01 fan belt ac

its your serpentine belt (thats what its called) and you will need a 3/8 ratchet and then find the belt tensioner. The tensioner has a spot where you need to put the ratchet into and pull or push depending on whatever way and that will releive the pressure off the belt so you can take it off.

Posted on Apr 17, 2009

emissionwiz

Marvin

  • 85239 Answers

SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE

This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.

Posted on May 22, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the pink wire for in the stereo of a 2006 Hyundai Santa fe? and what do I connect the dimmer wirefrom the santa fe to in a new stereo


The pink wire from the stereo unit is often the dimmer wire, and is connected to a power feed from the vehicle's side lights. Not all stereos have a dimmer function however, and may not have this wire available.

Nov 04, 2012 | 2006 Hyundai Santa Fe

2 Answers

Hyundai santa fe key fob 1 works 1 does not have changed battery deal says to buy new ,can i unlock with key without alarm going off


System operation
Pressing remote control lock button locks vehicle and activates system Fig. 1 . Indicators flash once. Pressing remote control unlock button unlocks vehicle and deactivates system Fig. 1 . Indicators flash twice.
Fig. 1
Synchronization
When
System malfunction. Remote control added or replaced.
How
Access alarm system control module located under driver's side lower fascia Fig. 2 . Set memory switch to SET position. Press remote control lock or unlock button. Set memory switch to OFF position. Confirm synchronization has been successful by locking and unlocking vehicle. Repeat procedure for second remote control. Synchronization can also be carried out using diagnostic equipment.
NOTE: A maximum of 2 remote controls can be programmed. NOTE: If remote control fails, system can be deactivated as detailed in the owner's handbook.

Jul 30, 2010 | 2003 Hyundai Santa Fe

1 Answer

What does 'Error 6' mean on the stereo of a 2002 santa fe?


jammed CD ?? honestly havent a clue have you tried looking in the radio manual ,or ask at the dealers

Mar 04, 2010 | 2002 Hyundai Santa Fe

1 Answer

2007 hyundai santa fe mil light stays on. had in


if it is still under warranty,take it back to them,tell them to fix it right this time, and yes you can reset only if you have a handheld device to plug into you car,still doesn't solve the problem though,"TAKE IT BACK"

Dec 31, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Hi looking to find the alarm relay it exact location on a 2007 santa fe crtd i want to fit a sound box so when you lock and unock it i can have a sound from it also the seat belt warning sound anybody know...


2007 Santa Fe already equipped with 'ANSWER BACK' feature. Propably still under warranty. Take vehicle to Hyundai dealership.. .have it diagnosed.. find out FIRST if system is still under warranty.

Jun 23, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Power locks with a mind of their own!


Sounds like a wiring/switch issue. I would have your dealer take a look at it to see if there are any problems with any of the switches, or the wiring.

Jun 11, 2008 | 2007 Hyundai Santa Fe Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...