Question about Hyundai Cars & Trucks

1 Answer

2003 Hyundai sonata just had front end aligned now it pulls when accelerated then goes back when let off accelerator

Posted by Brett Jones on


1 Answer

Mike Duffy

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Hyundai Master
  • 904 Answers

Take it back to the alignment shop and have them check for a "Torque steer" you may have a bad engine or transmission mount. I hope this helps. Take care.

Posted on Oct 21, 2019


5 Related Answers


  • 2 Answers

SOURCE: front end shakes when accelerating

The desciption you gave is exactly how it feels when you have an axle with a bad inner CV joint. It won't make a "clicking" noise like when you have a bad outer CV joint, but will shake pretty bad on accel. If you crawl under the car while it's on the ground (don't lift it) and grab on to the axle close to the inner CV joint and wiggle it, there shouldn't be very much play in it. If there is play in it, replace that axle.

Posted on May 01, 2009


Harvey N Tawatao

  • 3854 Answers

SOURCE: whirring noise front end 2003 yukon denali xl

Your front pump in the transmission could be going bad. Check the transmission fluid for level and condition. The fluid should be bright red and not burnt (dark in color like burgandy). Best thing to do is take it to a transmission shop and have them check your truck for DTC codes with a Tech 2 scanner and have them do a transmission line pressure test. The whining can also indicate low on transmission fluid and that's bad, you may have burnt some of the clutch packs already and shorten the life of your transmission. Good luck and keep me posted, be glad to help.

Posted on Jun 28, 2009


  • 35 Answers

SOURCE: when accelerating from approximately 0 - 20 mph

My immediate quick test would be to move the front tires to the back (and backs to front, of course) then try it out. If the vibration is still there but feels like it's coming from somewhere else (vibration could feel like it's in in steering wheel or seat), you've got a broken belt or bent rim (wheel). Don't want to get your hands dirty? Get all 4 wheels balanced -5 to 10 bucks per wheel.

Posted on Mar 14, 2010


Colin Stickland

  • 22485 Answers

SOURCE: i have a hyundai getz

mass air flow sensor in the air induction pipe between the filter and the manifold .

Posted on Jan 19, 2011

chad smith

  • 7 Answers

SOURCE: Front end shake & shimmy while accelerating on a 1997 Town & Coun

check cv joints as well possibly could be worn out

Posted on Nov 03, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2012 hyundai sonata accelerates on its own

Just keep foot close to brake peddle. Hahaha. Jk. Spray some wd-40 on your throttle body and throttle cable. If not that then take of throttle body and clean butterfly.

Mar 24, 2016 | 2012 Hyundai Sonata Hybrid Base Sedan 2.4L...

1 Answer

Clicking noise accelerating

Could be bad belts in tire or tires. Pulling to right especially under load is pretty common on front wheel drives.

Oct 14, 2017 | Hyundai Sonata Cars & Trucks

1 Answer

99 hyundai sonata accelerates on its own

check your oil level may be high.

Dec 14, 2013 | 1999 Hyundai Sonata

2 Answers

2001 hyundai sonata does not accelerate properly shortly after starting

check fuel pressure
change the fuel filter, it could be clogged up

Nov 07, 2017 | 2001 Hyundai Sonata

1 Answer

I have a hyundai sonata 2007 limited My car has both the esc off and the check engine lights on check engine is always on when the esc off light turns on the car runs very slow, it doesnt accelerate even...

These codes indicate your accelerator position sensor has malfunctioned. The computer has gone into limp mode, which allows you to drive to safety without damaging the engine. The computer is unable to determine how far you are depressing the accelerator and doesn't want to over-rev the engine. You need a new sensor.

Jun 17, 2017 | 2007 Hyundai Sonata Limited Sedan

1 Answer

How do you get the cruise contrl to work on a 2003 model coupe?

there is a lever under the washer fluid lever on your steering wheel. push in the button on the end of it then push it down to set your cruise, up to accelerate while using cruise, and pull back on it to cancel cruise

Aug 12, 2010 | 2003 Hyundai Tiburon

1 Answer

Loss of power will not pull up the hilin my driveway andwaterpump

This could be result of a malfunctioning accelerator - the accelerator on these cars is a "drive by wire" ssytem and sometimes need to be replaced. I had the same thing happen on my Sonata.

May 12, 2010 | 2006 Hyundai Sonata

1 Answer

Vibration in front of car during acceleration only. get more intense at higher speeds

have the constant velocity joints checked for excessive play, also have the tires checked, a seperated internal tire cord can cause this also, u can rotoate the tires to see if vibration gets better. Any tire shop will inspect the front end and the tires for free and give you a report.

Oct 03, 2009 | 2001 Hyundai Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides