Question about 2006 Pontiac Grand Prix GXP

Open Question

2006 GXP. How can I disable the chime on the driver information center?

Posted by James Stout on

Ad

1 Related Answer

Anonymous

  • 1071 Answers

SOURCE: The chime starts when the car is in motion

check for leaks or fluid level there is a sensor inline that could be bad unplug and look for moistur if fluid is in plug replace sensor

Posted on Jul 21, 2009

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
3answers
1helpful
1answer

How can I disable the door chime which is triggered every time I open the Drivers door of of my 1996 Lincoln Continental?

Its sensing that there is a key in the ignition. You have to replace the switch in the ignition cylinder that senses a key is inserted. Or alternatively access a wiring diagram and cut the wire from the key sensor to eliminate it.
0helpful
2answers

Disable passenger seatbelt chime

Hi Candy, I'm glad to help!

Candy, I'm not sure why you want to disable the pass seat belt chime, maybe its going off even with no one in the seat. BUT, the only way to stop it would be to plug the seat belt into the buckle. Hope this helps and have an awesome day Candy
0helpful
1answer

Which fuse controls the chime and turn signal sounds in a 2006 monte Carlo. I don't have either one of these sounds and was thinking that maybe I need to check the fuse that controls them.

The chime is integrated into the Body Control Module (BCM) and can't be disabled without turning off everything that the BCM controls, windows, wipers, security etc.
0helpful
1answer

Replaced the battery in my keyless entry fob and now it does not work. What do I do?

HAS TO BE REPROGRAMED
Perform the following steps:

Sit in the vehicle driver's seat. (actually it's much ezr from the front pass seat)
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode. If you do not hear a chime, start again at step 1.

Important
After 7 seconds, you may hear a chime confirming successful synchronization. After approximately 14 seconds, you will hear a chime confirming successful programming.
3helpful
1answer

My 2006 HHR traction control keeps engaging when it should not be

The traction control should engage any time the front wheels slip. The only way to disable it is to put the transmission in low 1. If it is engaging (Driver Information Center message) when the wheels are NOT slipping then you need to take the car to the dealer. The HHR is almost all computer controlled and there are very few user adjustments.
1helpful
2answers

2005 jaguar type-s. How can i disable the belt minder. The seatbelt alrm is making me crazy

To enable or disable the seat belt warning chime on your 2005 Jaguar Type S

1. Ensure the front passenger seat is unoccupied.

NOTE:

Steps two to five must be completed within 60 seconds.

2. Turn the ignition to the RUN position (do not start the engine).

3. Buckle the driver safety belt buckle and wait until the seat belt warning lamp extinguishes.

4. Unbuckle the driver safety belt buckle and wait until the seat belt warning lamp illuminates.

5. Repeat Steps three and four a further eight times.

6. When the driver safety belt buckle is unbuckled for the ninth time a single chime will be heard. The single chime is acknowledgement that the beltminder feature has been disabled.

The beltminder feature will be disabled until the above process (Steps one to six) are repeated. Upon repeating the process the beltminder feature will be reactivated
0helpful
1answer

Change oil message stays on even after repeatedly cancelling

Pontiac Aztek, Montana 2001-05 w/o (DIC) Driver Information Center; Torrent, Ascender 2006

Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. Turn the key to OFF If the CHANGE ENGINE OIL’ message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Pontiac Aztek, Montana 2001-06 wI (DIC) Driver Information Center

urn the ignition to ON, with the engine off. Press the MODE button until the DIC reads ‘OIL LIFE LEFT/HOLD SET TO RESET Press and hold the SET button until 100% is displayed. You will hear three chimes and the “CHANGE ENGINE OIL” message will go off. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Good luck
Not finding what you are looking for?
2006 Pontiac Grand Prix GXP Logo

Related Topics:

124 views

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6929 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14973 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...