Driver side sun visor falls down

I forced a small nail between the visor rod and the tube (or whatever) the rod goes into in the visor itself. That created enough tension or drag to hold the visor and keep it from drooping. The visor now works in all three positions.

replace it with an aftermarket tinted panel visor.the originals fall down for a pastime....

Already reported as being a repetitive problem with Murano vehicule owner eventhough they have it alreay replaced.
You can fight as long as you want with your dealer that this is a security issue no recall has been expressed about that so far.

I can say that some people switched the passenger side one with the driver side with little of convenience. I can't say more personnally.
The permanent fix being approx $250 unless you get it one in a scrap yard not knowing how long will be its life time! Up to you to make the decision.
Hope it will help
Dan

I have a 2003 Murano that just started having this problem a few weeks ago. As a quick fix, my husband and I switched the driver's side sun visor with the passenger's side sun visor (yes, everything is backwards now, but it's a minor inconvenience). It was very simple to do, and only took about 5 minutes. The cover pops right off to reveal two screws that hold the unit in place. Anyone could do it.
Meanwhile, we are searching local junkyards to try to find a replacement to avoid having to pay $250 (+) for a replacement visor.

I have found a few complaints at the following gov. site.
I have tried velcro which worked for awhile but now the glue won't stick to the roof material.

File a complaint here: (VIN # needed)
http://www-odi.nhtsa.dot.gov/ivoq/index.cfm

Search for the complaint - Visibility section
http://www-odi.nhtsa.dot.gov/complaints/index.cfm

2000 Sonata????.... fraid not. Buy replacement.

There is a small tensioning screw that should be apperant near the bent metal visor swing arm. Sometimes this screw will loosen up with use. I am not sure what type of head is needed to tighten this screw on your model of car. (Phillips tip is most common.)
Tighten it up a little at a time until it is like you like it.
Presto.

the unit has broken best solution is to get new visor, temperary solution would be use double sided sticky tape, safety pin or glue velco strips to both sides

thats an easy fix.the swivel is replaceable.or is their stuff on top of it? anywya it can be taken out and put back in 10 minutes

a creative solution is to use velcro tape. a piece on the visor and a matching piece on the roof liner

time to replace the visor assy's. If they have been used frequently this problem is common.