Question about Daihatsu Sirion

Open Question

How do I replace a headlamp bulb on Sirion 2008

Posted by H Roux on

Ad

5 Related Answers

Robert Sonmor

  • 58 Answers

SOURCE: I need info on how to replace the headlamp bulbs

The procedure is very involved.It requires the removal of the front bumper fascia fasteners from the center and side of the headlamp to be removed.

  1. Remove the front bumper fascia fasteners from the center and side of the headlamp to be removed, full removal of the fascia is not necessary. Refer to Front Bumper Fascia Replacement.
  2. Gently pull the fascia forward to allow clearance to remove the headlamp assembly.
  3. You will also need to remove some of the fasteners at the front of the inner wheel well.
  4. The Front Bumper Fascia is the plastic cover over your front bumper.
  5. You may also have to remove the plastic cover that is located under the front of the hood over the radiator.It extends to both sides.

Posted on Oct 28, 2009

Ad

Anonymous

  • 209 Answers

SOURCE: i have 2008 yukon. i have replaced 7 headlamps

Check the plug ins. Than check the light bulbs and see if they are melted If that is the case than you have to find the bad wires eather way it has something to do with your wires

Posted on Apr 20, 2010

Ad

Will Hammond

  • 2 Answers

SOURCE: how do i replace the

See this thread, this is how it is done, I hope this helps you.

http://cindyli.com/index.php/site/comments/vw_beetle_headlight_replacement/

Posted on Oct 04, 2011

ercupa190

ernesto cuadra

  • 12223 Answers

SOURCE: Replace headlamp bulb on 2008 Acura mdx, drivers side, how to do it? Thanks

go to www.autoelectronico.com and see how to change translate the page to english. i recommend you or www. automecanico.com
God bless you

Posted on Oct 05, 2012

alhenderson7

Al Henderson

  • 9 Answers

SOURCE: Can't get headlamp out 2008 BMW 328i to replace halo bulb

Take the black cover off the back of the headlight assembly and u should b able to access the bulbs

Posted on Nov 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace right front turn signal bulb on 2008 cadillac dts


My automotive database says you have to remove headlamp assembly to replace bulb. To remove headlamp assembly, you need to remove front bumper fascia.
Why in the world should you have to remove front of vehicle just to change a bulb, I don't know? My database is the only info I have to go by. I doubt I can walk you through it, step by step, I can't see anything from here.

Mar 01, 2016 | 2008 Cadillac Dts

1 Answer

How do you to replace a headlight bulb on Daihatsu Sirion 2007?


go to an autoparts store and ask them what bulb it takes then ask them how to change it . ,ost any more you remove them from under the hood by twisting and pulling out .

Jul 06, 2014 | 1998 Daihatsu Sirion

1 Answer

Chrysler Sebring 2008 headlight assembly removal


some times headlamp units have a plastic retaining clip on the underside of headlamp, does the headlight move from side to side? try to pull the headlight back from the top of unit then lift up the headlamp unit, if not it could be the headlamp adjusters holding unit in place.

Dec 06, 2013 | 2008 Chrysler Sebring

1 Answer

How do i install the bulb in the headlamp


Open hood reach behind headlight and remove bulb. If you can't reach bulb look at top of headlight ans look for screws or bolts. Remove them and pull headlight out and remove bulb. Replace bulb not touching glass if you do wipe with alcohol. Replace headlamp. If this helps please rate it. Thanks

Jan 04, 2012 | 2008 Chevrolet Equinox

1 Answer

How do you replace the drivers side low beam headlight on the 2008 GMC Acadia?


{: ) REMOVE THE LEFT FRONT WHEELHOUSE LINER
The wheelhouse liner is sometimes called the mud guard or the splash shield, whatever.
You may remove the left front tire.

-Start removing all those push pins and #7mm screws. No need to remove the entire liner. You may loosen only the half portion, just enough clearance for your arms to reach inside and aim for the rear of the headlamp.

-Reach for the Headlamp Bulb Accessory Cover. Rotate the cover counterclockwise and remove.

-Release the bulb from the headlamp assembly (turn counterclockwise) Disconnect the electrical connector. Just remember the positioning of the bulb so you can swiftly reinstall a new bulb.

Jun 16, 2011 | 2008 GMC Acadia

1 Answer

How do i remove the headlight


MKX
  1. Remove the headlamp bulb access cover.
All vehicles

  1. NOTE: To remove, rotate the headlamp bulb approximately 1/8 turn counterclockwise.
Remove the headlamp bulb.
  • Disconnect the electrical connector.
  1. To install, reverse the removal procedure.
140210177

Mar 09, 2011 | 2008 Lincoln MKX

1 Answer

How do I replace the driver's side headlamp?


Lift the hood and remove the bulb from the inside rear of the headlamp. The bulb assembly has ears on it that you use to unscrew the bulb. Look at the autozone link below to see the bulb. Installation is reverse of removal. Note: DO NOT TOUCH THE NEW BULB GLASS WITH YOUR FINGERS!! They are halogen bulbs and will burnout.



http://www.autozone.com/autozone/parts/Silver-Star-Headlight/2008-GMC-Yukon-2WD/_/N-js79yZ9ci8c?counter=0&itemIdentifier=862293_0_7179_

Sep 23, 2010 | 2008 GMC Yukon

1 Answer

How to change the headlight bulb on 2009 gmc sierra driver side


1. Loosen only, do not remove, the lower outside hidden headlamp bolt (2). 2. Depress the housing support tab with a flat-bladed tool downward in order to release the headlamp assembly from the support. 3. Pull the lamp assembly slightly forward to access the electrical connection. 4. Disconnect the forward lamp harness main electrical connector from the headlamp harness.
Headlamp Screws (Qty: 2)
1 Caution: Refer to Fastener Caution .
6 Nm (53 lb in)
O Headlamp Screw (Hidden)
6 Nm (53 lb in)
3 Headlamp Housing Support


Preliminary Procedure Remove Healamp
Remove either the LF or RF headlamp assembly. Refer to Headlamp Replacement (Chevrolet) Headlamp Replacement (GMC HD)
Headlamp Replacement (HD Diesel).
Headlamp Bulb (Hi)
Warning: Refer to Haiogen Bulb Warning .
Tip: Rotate the bulb socket a quarter turn counterclockwise and remove the bulb from the headlamp.
Headlamp Bulb (Lo)
Tip: Rotate the bulb socket a quarter turn counterclockwise and remove the bulb from the headlamp.

Need more come to https://www.autorepairhelp.us


change-headlight-bulb-2009-gmc-1pzbcmqursjjtd0qcfo11o2t-2-0.png change-headlight-bulb-2009-gmc-1pzbcmqursjjtd0qcfo11o2t-2-1.png

Aug 14, 2010 | 2008 GMC Sierra 2500HD 2WD

1 Answer

I have 2008 yukon. i have replaced 7 headlamps


Check the plug ins. Than check the light bulbs and see if they are melted If that is the case than you have to find the bad wires eather way it has something to do with your wires

Apr 20, 2010 | 2001 GMC Yukon Denali

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daihatsu Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Daihatsu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...