Question about 2002 Jaguar S-Type
Do you mean 'parking brake fault' This message can sometimes appear with low battery causing the electronic park brake to lose its calibration.
To recalibrate it disconnect your battery and leave for 10 Min's. then reconnect and with the ignition on apply the foot brake and whilst keeping applied switch the parking brake on. then release the foot brake turn ignition off - on and the handbrake fault message should be gone and the parking brake should release as you drive off.
IMPORTANT - make sure you have you radio code as you will need this after a battery disconnect.
hope this helps - good luck
Posted on Sep 24, 2009
Identical problems in the recent snow. Drove until first stop and then park brake locked on and Selector stuck in P. Jaguar Assist called and passed to AA. Selector sorted by lifting and moving lock located to left of gear stick. Brake still locked on. Battery removal no go. Removed the two plugs from Park Brake module (right hand side boot level with fuel filler. Applied 12v from battery across thick green and white and red and white wires. Reverse polarity until motor heard winding off brake. The drive to dealer (no application of brake or shift in P) and pay him £100 to reset the software. Apparently it goes into a loop if wheels spin on ice with EPC engaged. Avoid by turning EPC off in extreme conditions.
Posted on Jan 17, 2010
My S type parkbrake motor is starting to make funny noises and the "Parkbrake Fault" message appears. I need a new motor about £90 cost + labour. This can't be done for another two weeks so to stop it failing and leaving my brakes on you can do the following to ensure it does not come on when leaving the car.
Put the automatic gearbox in "parking" and push the parkbrake button down (i.e. to ensure it does not come on). Keep it pushed down and take the ingnition keys out of the it will not start the parkbrake motor. Whe you next get in the car, you will not see the "Park" light come on meaning the parkbrake is not on.
Only do this if the car is on the flat to be safe.
Posted on Aug 23, 2010
Copy of e-mail to Taunton Jaguar
"The vehicle was imobolised by a computer failure on 18th January 2010. On reporting my problem to your company, as the car was supplied by you and having done under 10,000 miles is under warranty, I was refered to the AA. An engineer promptly appeared and carried out, what proved to be a tempory repair, and I was able to attend a meeting three hours late. On 28th January 2010 I lost another afternoon whilst you arranged for the car to be returned to your garage. A day and a half has passed and I have received no phone call or any contact as to whether you have got the vehicle, if it can be repaired, and how long will I be without the car?"
Posted on Feb 01, 2010
My 2006 S Type dispalyed the message 'Parking brake fault' after sliping on an icy surface and using the anti slip button. The AA disconnected the battery without sucess - but not for 10 minutes. Perhaps that would have solved it.
The car had to be recovered to a dealer - its too clever for its own good!
Posted on Dec 19, 2009
hi mike i had the very same problem with my 55 plate s type this morning 4 feb 2009 had driven a journey of 20+ miles at 9am with 4" of snow on the ground and at this point no problems and i would assume the discs and pads would have been toastie hot and the assoc parts ,
but after a quick stop for ten minutes i restarted the car and drove away up a slight incline in snow /slush the rear wheels lost traction and the dsc sybol illuminated on the dash after getting no traction in this mode switched dsc off and managed to get some traction by hook or crook on reaching the major grit treated road and gaining full trction the dsc was re selected
as per normal start up but then i noticed that i had the amber oval warning light on the dash and park brake fault promt on the info lcd .
On stopping the car i tried to switch off the engine and re start to see if this would reset or clear the display
resulting in the car still showing same fault msg and this time unable to select a gear and the gear selector stuck in park
on calling jaguar assist an engineer arrived within a reasonable time with laptop and conections to do a diognostic scan
finding that his pc would not cummnicate with my car following several attemps the engineer went on to get the park brake disengaged by these next two steps and i can only say that this worked sufficently to get the vehicle off the road to a more suitable investigating area
in my case my drive way less than 1/4 mile away
step 1. inside the boot lift the floor to expose spare wheel and battery compartment
then on drivers side, the interior that covers the rear light cluster should be teesed back there are two black fixings that secure this in place one being 1/4 turn the other a full thread plastic nut
once this liner is pulled back (easier with two people )there is a white (PARK BRAKE ) module sat there with a multi plug going in .
this multiplug contains severa wires going into it.
from what the engineer said the two your intrested are clearly fatter than the rest and control the motors that engage parking brake force to the calipers .
now heres the clever bit take 2 peices of wire at least 2 feet long making sure the ignition is off and key out
(this is also where a friend comes in handy )
where the battery is, remove the cover from atop of the live + terminal and place place /hold /secure one wire to each batery terminal this done then carefully touch the exposed other ends of each wire into the little gaps where the individual fat wires go into the multiplug trial and error will do one of two things
1/ nothing and the brake motors will just remain powered to keep brake force applied so by swapping them round should give the desired result in powering the motors to RELEASE breaking force and thus disengage
REAL IMPORTANT NOTE MAKE SURE THE VEHICLE CAN NOT ROLL ,OVER YOU ,OR AWAY ,CHOCK A WHEEL OR TWO WITH SOME THING BLOCK OF WOOD BRICK MOTHER IN LAW YA GET MY DRIFT
so stage one complete but error msg and drive selector still not moving
center console where ashtray is ,lift cover to expose cigar lighter
the trim panel that is sheild shaped and surrounds the gear selector should be grasped firmly by placing your four fingertips along the flat top area where it meets the ashtray and prise upwards toward the roof this removes the trim plate without any damage and exposes the Jgate selector linkage and the plastic dust shroud that rotates when various positions are selected .
now on the pasenger side look into the gap that has become visable and a small aprox 1/2" to 3/4 " protrusion with a flat straight lump similar to a slotted screw but in reverse if you get my drift sits on the side of the selector by rotating this button/protrusion with your finger tip or screw driver tip and trying to move the gear selector from its park position this should allow the selector to move down the gate,while the engineer did this in my case i was sat in the drivers seat and had the car held on the foot brake so that the normal protocols of selecting were observed also the engine was running on moving the selector neutral was selected and at no time was park re selected til the vehicle was recovered to my drive way
however whilst driving the car the parkbrake fault warnings were still present and the asssoc beeps were audible .
strangly once we were on my drive the car was re plugged in to diagnostic laptop after the engineer had tried it on the land rover disco he had attended in and this done just to elliminate that his laptop and cables were funcioning correctly which they were ,
my car began to communicate with his machine and a reset was done
the get you out the S**T CHEATS were put back to normal
the PARK BRAKE FAULT warning was cleared and so far so good
its been very intresting to note that all the posts i have read on the web seem to refer to 2005 models and that adverse wheather conditions seem to play there part i was relieved to have this fixed and very grateful to the engineer who was so very helpful and happy to share his wealth of knowledge without which i could not have passed this on
Posted on Feb 05, 2009
If the brake will not release or not apply, try the following (making sure you have a fully charged battery) Disconnect battery for 10 mins ( make sure you have your radio code available- this will need to be entered after battery reconnected to use you radio) when battery reconnected follow instructions on your dash board message centre. If this fixes your problem the the fault was caused by low battery voltage. If the fault remains you have a problem with the brake module or motor. If the brake shows no fault messages but you still have a problem it could be a mechanical problem with the brake assembly which will need inspection. Hope this was of help - good luck.
Posted on Jan 10, 2011
Tips for a great answer:
Mar 01, 2018 | Jaguar Cars & Trucks
May 28, 2017 | Jaguar Cars & Trucks
May 28, 2015 | 2004 Jaguar S Type
May 09, 2011 | 2005 Jaguar XJ-Series
Jan 17, 2011 | Jaguar S-Type Cars & Trucks
May 26, 2010 | 2003 Jaguar S-Type
Feb 18, 2010 | 2000 Jaguar S-Type
Feb 08, 2010 | 2005 Jaguar S-Type
Sep 07, 2017 | 2004 Jaguar S Type
17,077 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: