Question about Cars & Trucks
This is likely a bumper off job. If you are not opting for a service manual, the following may be of some assistance.
Links below offer some insight regarding "clips" on Renaults.
The following ebay page list some grille parts including
Black Universal Aluminium Racing Race Honeycomb Mesh Grill Grille Bumper Vent (Fits: Renault Scenic II)
Haynes Publishing offers service manuals.
Posted on Aug 14, 2019
when you say the bonnet has been pushed in do you mean like in a traffic accident if this is the case then is your grill damaged,the reason i say this is the only way you are going to open your bonnet is through your grill so a replacement grill will be needed.if you take this course of action,take a torch and look up under the bonnet you will se the bonnet realease at the very front of your bonnet it will have the bonnet realease cable attached you might need help at this stage,get a friend to push down on your bonnet,put your hand in and push or pull the lever until it releases as this works on a hook system and with the damage it might need a pretty stronge screwdriver to force it always remember the radiator is very easly damaged and very costly to replace .Hope this will help you get your bonnet open .adrian
Posted on Feb 14, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
Posted on Sep 23, 2009
Most likely to be a faulty resistor block, which has 3 resistors and a thermal fuse controlling fan speeds 1,2 and 3, maximum speed 4 by-passes the resister block. It may also be poor electrical connections to the resistor block caused by overheating. Renault ask for approximately £350 to carry out repairs, a replacement resistor block will cost £50. If you decide to carry out the repairs yourself, be advised that if you are not competent to carry out such work you, could cause electrical damage or worse an electrical fire.
Posted on Nov 14, 2009
Tips for a great answer:
May 16, 2017 | Renault Cars & Trucks
Feb 21, 2015 | 2005 Renault Megane Scenic
Dec 29, 2014 | 2006 Renault Scenic 1.6
Aug 09, 2014 | Renault SCENIC Cars & Trucks
Feb 11, 2010 | 2003 Renault 181
Dec 29, 2009 | Renault 18I Cars & Trucks
Jan 23, 2009 | 1986 Renault Sport
Aug 21, 2008 | 2000 Renault 181
34 people viewed this question
Usually answered in minutes!