2000 Daewoo Nubira camshaft position sensor

• check for continuity between the two outer pins with a multi meter

p0463..... fuel level sensor A circuit high input...... thats the problem

• Right on the front of the cylender head. Remove the connector and the mounting bolt and remove and replace.

• Hope this helps.

There different kinds of Cam sensors, Just by the cheap one around $60 and put it in yourself and save your self money because your car is 2002 and not under warranty any more and if your sensor failed then you need a new one,And Not that hard to do. Good luck

If I recall correctly there was a recall on the camshaft position sensor. In some cases it would melt.
MAKE: DAEWOO MODEL: NUBIRA YEAR: 2001 DEFECT SUMMARY:
ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.
CONSEQUENCE SUMMARY:
THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.
CORRECTIVE SUMMARY:
DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. THE RECALL BEGAN ON SEPTEMBER 7, 2004. OWNERS SHOULD CONTACT DAEWOO AT 1-877-362-1234, OPTION 6, OR FIND A LOCAL DEALER THROUGH THEIR WEBSITE AT WWW.DAEWOOUS.COM.

remove eng cover. it is at the front of eng neer timing belt, to re place timing belt must come off good luck

hi,
it is under the upper timing belt cover between the camshaft gears. According to the manual touching anything related to timing belt requires removing million parts including right front wheel. I suspect this might be an overkill just to remove upper timing belt cover.

So my advice would be to get it done by some mechanic as u will not be able to do it and may damage other parts also.

Thanks!
Sandy

when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car

The IAC valve requires resetting .
First locate the IAC valve located on the side of the throttle body and has 4 wires going to it .Procedure is as follows
Ignition key on ,unplug the IAC ,turn key off ,reconnect the IAC .do this 3-4 times .restart the car and hold the rpm at 2000 rpm and slowly lower until it idles by it self .

Here is a Pic of the location The arrow points to the CKP (crank position sensor) It is next to the pulse wheel.