Question about 2001 Chrysler Concorde

1 Answer

My 2001 chrysler sebring will not shift out of 1st gear

I notice when i turn the key three times two codes apper on the dash.they read p1684 and blank lines show up then the code p0700 right after that the engine light flashes on and off about 3 times then the word done comes up. thats all it does ...what do i do, or what do the readings mean?

Posted by bgallegos26 on


1 Answer

Steve Pack

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 4,331 Answers

The fault code P1684 means that power to your powertrain control module (PCM) was interrupted. The most common cause of this is because of a weak battery. When the car is stated, the voltage drops low enough that it cuts power to the PCM for just a brief moment, which will set the fault. It can also be caused by a wiring issue to the PCM, or a bad connection in the battery cable. It may or may not cause issues with drivability. The fault should be thoroughly diagnosed by a qualified technician

What the P0700 code means. P0700 is set when the PCM detects a malfunction in the transmission control system. This malfunction causes the vehicle to set a Check Engine Light and trigger a failsafe mode. Once the failsafe mode is set it will remain until the fault is repaired or normal operation is detected

Posted on Jan 31, 2018


5 Related Answers


Colin Stickland

  • 22485 Answers

SOURCE: 2001 chrysler sebring will not go above 25 code p0700 p1684

something has triggered the fail safe ,could be anything from a tail light bulb out to low brake fluid level,but i could be wrong of course and no doubt i am.europeon cars use encrypted software thats designed to be dealer only, american cars ??dont know about this but iam assuming their standard as lots of boy racer ,sunday car mechanics type tools for fault reading??here on a europeon car they tell you your not connected ??connection pins in different places and encrypted software.. makes any fault a dealer only job and lots of money,just to connect computer is around 80€ before you evan pay labour .

Posted on Dec 20, 2008


Jonah Oneal

  • 14092 Answers

SOURCE: Engine light codes P0551 and P1684


Posted on Aug 23, 2009


danny herget

  • 1627 Answers

SOURCE: 2001 chrysler van has code p0700 and it wont shift

You have an internal pressure leak and will likely need a new tranny,sorry but you can take it to a transmission shop to confirm.

Posted on Nov 06, 2009


Jeffrey Turcotte

  • 8984 Answers

SOURCE: I have a 2001 Chrysler Town & Country LX. I

302 is misfire on cylinder 2. Please see my tip at .
1684 is battery disconnected, which you caused when you disconnected it--you can ignore that. You probably have an intermittent misfire. Please follow my troubleshooting steps and let me know if you have questions.

Posted on Dec 01, 2010

Peter da techmen

  • 184 Answers

SOURCE: engine code reads P1776 1/2 and P0700 transmission

P0700-This Relates to MIL"Malfunction Indicator Lamp")( Request - Control System for Transmission
unable to locate description for P1776,can you get all systems scanned for codes again as 0700 just indicates that a fault has occurred that has lit the check light and logged at the ECU.
Obviously it will be related to the shift fault,maybe a speed sensor or a dirty fluid fault.
Get back to me with any extra info.

Posted on Apr 10, 2011

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car won't start there is power to the starter. Starter is new. p1684 code the dash lights reset and says done and the the code p1684 comes on. Also you can not tell what gear the car is in there...

I just wanted to show you what I found on the internet regarding p1684:
"P1684 engine code

The P1684 code simply means that the battery has been disconneted within the last 50 starts."

May 16, 2011 | 2002 Chrysler Voyager

2 Answers

I have a 2001 Chrysler Town & Country LX. I turned the ignition switch on and off two times. When I turned it on the third time, the odometer started registering codes. The first code was p0302. ...

302 is misfire on cylinder 2. Please see my tip at .
1684 is battery disconnected, which you caused when you disconnected it--you can ignore that. You probably have an intermittent misfire. Please follow my troubleshooting steps and let me know if you have questions.

Dec 01, 2010 | 2001 Chrysler Town & Country

2 Answers

Chrysler sebring 2001 key wont turn

1) Wrong key 2) Shift lever out of park or neutral 3) If steering is locked, it is exerting too much pressure on the ignition, try jiggling it while turning key.

Feb 15, 2010 | 2001 Chrysler Sebring

2 Answers

2001 Chrysler Sebring does not shift. I can put it in reverse and drive and it runs, but it does not shift out of first gear. Speedometer still works. Transmission fluid shows that levels are fine.

might be a pluged filter in the transmission check that and it could not hurt to take it to a transmission shop to have them run a trouble code on the tranny

Aug 31, 2009 | 2001 Chrysler Sebring

1 Answer

2001 chrysler sebring convertable key stuck in ignition -

Is the gear shift button stuck in, if so hit the gear shift a couple of time and that should unstick the botton, allowing you to remove your key

Jul 04, 2009 | 1998 Chrysler Sebring

1 Answer


Hi, a P1684 is "Battery Disconnected Within Last 50 Starts". I wouldn't worry about that too much.

The P0340 is "Camshaft Position Sensor Circuit Malfunction". I'd definitely look into that code. I found a great article specific to the p0340 code - - it should give you an idea on what to look for, test, replace, etc. Good luck!

Mar 14, 2009 | 2001 Chrysler Sebring

2 Answers

Code p1684 2002 chrysler

Check,tighten & clean all battery connections & Have your battery tested.Load tested. Usually a weak, or defective battery will cause this code to come up also. While they're at it, have them test charging system. My guess is autozone will check it free or cheap, if you buy the new battery there if required. Have you noticed it turning over maybe a little slower when starting occassionally?

Feb 23, 2009 | 2002 Chrysler Sebring

1 Answer

2002 Chrysler Sebring Convertible

Code 1684 metering oil pump temperature sensor circuit malfunction.
Have you checked the alternator? It sounds like it is not charging the battery. countrycurt0

Sep 07, 2008 | 2002 Chrysler Sebring

1 Answer

Battery Light on dash board comes on... here is a link to a website that lists all code for Dodge.

That perticular code is
Metering Oil Pump Position Sensor Circuit Malfunction

I have never seen that one before I will do some checking to see if I can find some thing on it.

Jul 21, 2008 | 2004 Chrysler Sebring

1 Answer

2001 sebring 4 door 2.7

It could be the neutral safety switch if it is an automatic transmission car. If it is a manual transmission car their is a safety switch in the clutch pedal. If these check out ok then check the starter solenoid

Jul 08, 2008 | 2001 Chrysler Sebring

Not finding what you are looking for?
2001 Chrysler Concorde Logo

Related Topics:

357 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides