Question about 2002 Oldsmobile Alero
How to change water pump in 2002 oldsmobile alero and a diagram of the engine? and where to start from the top of engine or side by the tire?
I suggest that you visit the autozone.com website and register the vehicle. It doesn't cost anything and will give you access to an online repair manual. The steps for replacing the water pump should be available there. Hope this helped and best wishes.
Posted on Sep 01, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Oct 02, 2014 | 2002 Oldsmobile Alero
Apr 16, 2014 | 2002 Oldsmobile Alero
Jul 06, 2011 | 1999 Oldsmobile Alero
Jun 27, 2011 | 2002 Oldsmobile Alero
Mar 17, 2011 | 2000 Oldsmobile Alero
Jan 22, 2011 | 2002 Oldsmobile Alero
Remove the negative battery cable. Using a screwdriver, loosen the screw that connects the negative battery cable to the battery post. Pull the cable away from the post.
Lift th car using a jack. Support the Oldsmobile Alero with jack stands and the engine using a lift or some other engine support device.
Drain the Oldsmobile Alero's colling system by opening the cap on top of the radiator and unplugging the drain plug underneath the radiator. Position a large container under the drain hole to catch the draining coolant.
Disconnect the components that lead to the water pump with an adjustable wrench Lay them out in the order removed. In order, these parts include the automatic transaxle (if equipped), front wheel on the right side, splash shield, water pump sprocket and the access plate to the timing cover.
Use the access plate bolts to secure the water pump sprocket holding tool to the engine cover. Remove the pump bolts, front cover, thermostat housing, water pump feed pipe and two engine bolts using the adjustable wrench. Lift off the water pump.
Remove the bolts that secure the water pump to the block. Take off or scrape away the gasket. Remove and discard the o-ring between the water pump inlet pipe and the pump.
Spread a small amount of sealant on the water pump, on the areas where it mounts to the engine. Place the gasket on the sealant. Position the water pump onto the engine.
Insert the new bolts into the water pump. Torque the bolts to 89 inch pounds torque. Reconnect the other components in the order removed using an adjustable wrench.
Re-insert the drain plug into the radiator. Remove the engine support and jack stands. Lower the Olsmobile Alero to the floor.
Refill the radiator with coolant according to the instructions in your owner's manual. Screw on the radiator cap. Attach the negative battery cable to the post. Close the hood and test the car.
Nov 30, 2010 | 1999 Oldsmobile Alero
Oct 02, 2010 | Oldsmobile Aurora Cars & Trucks
2,031 people viewed this question
Usually answered in minutes!