2003 RANGE ROVER DRIVER DOOR PROBLEMS.

Question edited for clarity.
Question moved to model category

Check fuses first. Videos here

https://www.google.com/search?q=2008+Range+Rover+HSE.+Where+is+front+door+control+module+located

..

Some people pour warm water on the door top to thaw it out.
Hope this helps.

window came off or disconnected on inside of the door. Remove door panel to fix. Good-Day!

look at what is going on inside of drivers door by pulling window handle to pop door panel so you can see inside.

Check the batery in your remote

Has the window motor been replaced? This is a classic symptom of defective window motor. Next time this happens hit the door panel, if the window starts working again that confirms the problem is the motor. This is not fool proof but in most cases the motor will restart, hit the panel down low a few times.

Unfortunately, there is a trick to replacing the battery.
1) Open the Driver side door.
2) Open the Bonnet and take the battery cover off.
3) Use your remote to lock and unlock the car (keeping the driver side door open)
4) Pull the Negative Lead from the battery first, followed by the Positive Lead.
5) Change or replace with charged battery.
6) Closed down Bonnet.
7) Your windows, sunroof, and key FOB will not work... so follow the next steps.

7a) Insert your key, with door closed into the exterior lock on driver's side.
7b) While turning the key to lock the door, hold down the "lock" button on your remote for 5 seconds while in "lick" position
7c) Your remote will reset, and you should be able to use your remote now
7d) While driving, roll each window down twice. On your third attempt, you should only have to touch the window button, and the window will have reset

Enjoy your Rover!
MIke

check and see if the window lock is on or not, driver side window and sunroof will still function when window lock is activated however, the other windows will not work, even by the drivers control, it should be the button on the top right next to your power door lock switch,

There may be another relay in the drivers door for the automatic touch feature. If you also have a switch on the drivers door follow the wires down to this second relay. If you don't have a second relay then try to jump the wires at the door to power the motor in both directions. If you can do that, the door switch is bad on the "up" terminal.
The regulator can be broken and you can see that with the door panel off. The motor terminals may have corrosion and you can probably reach that plug with the door panel off.

the motor has a clutch inside that wears out. its one assembly. replace it and you should be good to go.