2005 Honda CRV wiper pump doesn't pump fluid out.

I would bet that the 30 amp fuse feeds the motor and the 10 amp fuse feeds both of the switches. Can you remove the rear trim to gain access to the rear motor and unplug it?

Might be just the wiper arm retaining nut has loosened and the spindle is turning but not moving the wiper. If that isn't the cause a connecting rod has probably detached from the linkage which usually needs some trim removal for access and sometimes more...

I would start by checking fuses. If you've checked already, then the windshield washer pump has probably gone bad. The wiper motor and washer pump should be separate units. Typically the washer pump is located in the base of the washer fluid reservoir.

Either the pump is bad, or there is blockage in one of the supply lines to the sprayer. Have someone activate the washer switch while you listen under the hood to see if the pump makes a noise. If it does, unhook one of the lines at the firewall and below the sprayer to see if fluid is flowing out. If it is, you need to unplug the sprayers. If the pump makes noise but no fluid gets to the line, look for a blockage between the pump and the end of the line. If the pump makes no noise, check the fuse block for a bad fuse, otherwise assume the pump is bad.

Sometimes disconnecting the battery does more damage then you want it might have trip a fuse or relay check those if thats not it, maybe wiper motor or transmission went out.

It can be faulty wiper motor or blown wiper control fuse.

Do you hear any kind of noise when you starter the wiper function. If yes then fuse is ok, but issue is wiper motor.

If no movement at all and no noise then its blown fuse or shorted/loose wiper control wiring:-----

For complete troubleshooting i suggest you few helpful links with accurate solutions.

-------------

Click the link below:-------

1993 Ford F350 wipers not working?

http://repairhelpcenter.blogspot.in/2012/02/1993-ford-f350-wipers-not-working.html

------------

How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

------------

Wipers not working, but hear relay click on Lincoln LS?

http://schematicsdiagram.blogspot.com/2011/12/wipers-not-workingbut-hear-relay-click.html

-----------

Car windshield wiper gets power for movement and stops?

http://schematicsdiagram.blogspot.com/2011/12/car-windshield-wiper-gets-power-for.html

----------

How does cars Windshield Wiper System Works

http://technoanswers.blogspot.com/2011/11/how-does-cars-windshield-wiper-system.html

---------

1997 Honda Protege: Replace Wiper Transmission?

http://technoanswers.blogspot.in/2012/06/1997-honda-protege-replace-wiper.html

----------------

Windshield wiper fluid container leaking?

http://whatisbyme.blogspot.in/2012/05/windshield-wiper-fluid-container.html

-----------------

Where is wiper fuse located on1993 chevrolet suburban

http://technoanswers.blogspot.in/2012/02/where-is-wiper-fuse-located-on1993.html

------------

2002 Toyota Sienna: Wipers and Passenger side Power window stopped working?

http://technoanswers.blogspot.in/2012/04/2002-toyota-sienna-wipers-and-passenger.html

-------------

Complete wiper components replacing details for Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/complete-wiper-components-replacing.html

------------

These details will help.

Thanks.

CHECK VOLTAGE AND GROUND AT WASHER PUMP MOTOR WHILE ACTIVATING UNIT. IF VOLTAGE AND GROUND PRESENT DEFECTIVE MOTOR,IF NOT DEFECTIVE SWITCH,FUSE

After you pour the stuff in watch where it comes out. It is buried in the fender ...drivers side. Wheel well shield is removeable.

You could have debirs in the pump or in the line. some units have screens that can get clogged up. Do make sure fuse is in place and tight. There may also be a relay that could be loose or faulty. You can check with an ohmmeter.

WHEN YOU TURN ON WASHERS CAN U HEAR THE PUMP WORKING IF YOU CAN IT WILL BE
BLOCKED WASHER JETS OR LINE OR WASHER PUMP IS FAULTY.