SOURCE: need torque settings for 1985 4A corolla cylinder head
hey, torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:
9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10
SOURCE: Angle Torque settings head bolts
Use new bolts, tighten in the following stages
1. 20Nm
2. 100Nm
3. wait 3 mins
4. slacken bolts 1&2 retighten to 20Nm +110 degrees
5. carry out stage 4 for bolts 3,4,5 & 6
then bolts 7,8,9 &10
Sequence,
8 4 1 5 9
7 3 2 6 10
Bolts 9 & 10 are flywheel side of the engine.
SOURCE: Hi I'm looking for cylinder head torque settings for a 1992 BMW 316/318 e36
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
SOURCE: torque setting cylinder head bolt 4 cylinder KIA sportage
I need the torque settings and pattern for a Kia Sportage 2.2
1,840 views
Usually answered in minutes!
×