Question about 2006 Acura TSX

Open Question

Coler Wireing order for 3 pin crank sencer connector For a 2006 acura tsx

Posted by Justin Leboeuf on

Ad

5 Related Answers

ginko

Ginko

  • 19396 Answers

SOURCE: radio pin code

Try this:"disconnect the battey cables and touch them together for ten seconds. reconnect them. turn key to accessory or on. make sure radio is off. press and hold radio presets one and six. continue holding and turn on radio. it will display the serial number in two parts. for example "u1234" and "l4321". drop the u and l and you have the serial number. call the dealer with the number and they can look up the five digit code. you may have to prove ownership of the car though."

thanksboyhonda5

Posted on Jul 24, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: oil reset light

how do i reset the oil light on tsx

Posted on Aug 27, 2009

Ad
greg_margo

Greg Margossian

  • 1959 Answers

SOURCE: How do I reset the oil life indicator on my Acura

To reset MAINTENANCE REQUIRED light, turn ignition off, press and hold the SELECT and RESET buttons. Turn ignition on and hold buttons for 10 seconds until indicator resets.

Posted on Sep 06, 2009

super_guy

  • 1986 Answers

SOURCE: headlights adjustment on 2006 acura tsx

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

If you have one adjustment screw, it will control your vertical aim. If you have two adjustment screws, one will control your vertical aim and the other will control your horizontal aim

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Posted on Sep 30, 2009

Michella Linton

  • 58 Answers

SOURCE: asking for code for my acura tsx cause i chang my ...

You have to do this: If you have jumped or replaced the battery at anytime this will happen. You have to get the serial number off the radio by removing it or partially taking it out to see the numbers on it try not to remove any cords. With the stereo out (to make sure you get the right number off of it) call an Acura dealership with the number and they will give you the another number to enter into the stereo and directions on how to punch the numbers in. Make sure while you have the stereo out you write the serial number down and keep it in a safe place also the number that the Acura dealership gives you because if you sell the car or if it happens again its easily accessible. Good Luck!

Posted on Aug 23, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Acura TSX makes a rattling type of noise when it is fist cranked after sitting overnight- local xperts think it is the catalytic converter.


that or motor mounts mine rattles till you put it into neutral and it stops so check motor mounts also

Jul 02, 2011 | 2006 Acura TSX

2 Answers

Radio pin code


Try this:"disconnect the battey cables and touch them together for ten seconds. reconnect them. turn key to accessory or on. make sure radio is off. press and hold radio presets one and six. continue holding and turn on radio. it will display the serial number in two parts. for example "u1234" and "l4321". drop the u and l and you have the serial number. call the dealer with the number and they can look up the five digit code. you may have to prove ownership of the car though."

thanksboyhonda5

Jul 24, 2008 | 2006 Acura TSX

Tip

What is the firing order for 2004 Acura TSX 2.4 liter DOHC L4?


the firing order for 2004 Acura TSX 2.4 liter DOHC L4 is :-- 1-3-4-2 -------- placed in lower side as 4321. -------- This will help.Thanks.

on Mar 19, 2010 | Acura TSX Cars & Trucks

1 Answer

Acura tsx 2006 drl message on and daylights dont work


check the bulbs? they could've went out

Feb 05, 2011 | 2006 Acura TSX

1 Answer

How do I reset the oil life indicator on my Acura TSX 2006


To reset MAINTENANCE REQUIRED light, turn ignition off, press and hold the SELECT and RESET buttons. Turn ignition on and hold buttons for 10 seconds until indicator resets.

Sep 06, 2009 | 2006 Acura TSX

3 Answers

Oil reset light


how do i reset the oil light on tsx

Jun 09, 2009 | 2006 Acura TSX

1 Answer

2006 TSX lost radio when battery died - how to recode?


Sorry the only way to get the code is thru the dealer

you must provide proof of ownership.

Mar 30, 2009 | 2006 Acura TSX

1 Answer

Km-miles


sorry.. i have no idea... read the manual

Jul 24, 2008 | 2006 Acura TSX

Not finding what you are looking for?
2006 Acura TSX Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...