SOURCE: Mazda Sentia 929 auto failure
Rebuilt gearbox probably... unfortunately!
If the HOLD light in the in strument cluster is flashing at you, it is giving you a transmission diagnostic code (like a kind of Morse Code). A transmission specialist or a Mazda Dealer will be able to read this code and plug their computer into the cars computer, and tell you what is wrong.
SOURCE: 2004 Mazda 6 AT light = hard clunk putting it into gear
solenoid may be going out. to keep from having to shell out big buck later on, take to the dealer for a $60-80 diagnostic fee if it's out of warranty.
SOURCE: 05 Mazda 6 I need to replace the headlights
Behind the head lamp you'll see a circular cap with some fins on it. Turn it counter clockwise and then it should come out exposing the back of
the bulb. Then you will need to push in and up on an angle to release the metal spring clip that holds the bulb in place. Then you can disconnect the harness to the back of the bulb and then remove the bulb. Do not touch the glass of the bulb when putting in the new one as that will cause the bulb to catastrophically fail
SOURCE: just changed rear brake pads on 05 mazda 6. now
This is normal and you need to keep pumping the brakes till they reset there self. Once the brake peddle have reset there self and is firm, check the brake fluid level again and add brake fluid if low. After brakes have reset there self, go for a test drive around the block and check the parking brakes. Good luck.
SOURCE: Car will not go into the last gear
Sounds like something is wrong with your overdrive, is your hold light flashing?
94 views
Usually answered in minutes!
×