- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Remove mirror mount cover assembly.
Remove inside door handle cup (22634).
Remove door lock control bezel.
Remove window control bezel.
Remove interior lamp lens.
Remove screw from interior lamp assembly body.
Remove screw from window control bezel opening.
Disconnect mirror, lock switches and memory seat on driver side from bezels and wire harness.
Disconnect window switches from window bezel and wire harness.
Lift front door trim panel (23942) vertically, out of weatherstrip and over lock rod.
Disconnect interior lamp (13776) from wire harness.
Remove front and rear door trim retention hooks into door inner panel.
To install, reverse Removal procedure, paying special attention when inserting inner door trim into weatherstrip. Rock inner door trim into weatherstrip and push downward until lower trim belt character ditch lines up with score mark on inner door panel.
This is theinstruction on how to remove door panel of Toyota camry
1. Openthe door as wide as possible and roll the window up completely. Locate andremove five screws and two clips in the door panel. Two screws are located atthe rear of the panel, another two are located under the arm rest, one near thelight and the other in front of the light. The last screw is located in thefront of the arm rest behind a triangle shaped plastic panel, directly belowthe door handle. Pry this panel up with a flathead screwdriver to remove thescrew underneath. The two clips are near the front of the door and are smallplastic circles. Push them in with a small screw driver and pull them out.
2. Remove the plastic trim around the doorhandle. Use a flathead screwdriver or prying tool to pop the plastic out fromthe door panel. Wiggle it around until it comes loose from the door handle.
3. Use a flathead screwdriver or prying tool atthe bottom edge of the door. Pry away from the door until the clips under theedge pop out. These are plastic clips under the edge of the bottom and sides ofthe panel. Gently pop them out from the entire door panel. The top of the panelis held in place by the window trim. Move the panel back and forth until it isfree from the window trim.
4. Unclip the wire connectors and wires with aflathead screwdriver. The door panel is now free from the door.
its on the driver sidde of the engine. You will see the radiator hose running to the thermostat housing. You must remove the radiator hose and thermostat housing to see it. also make sure your radiator caps seals aren't leaking, especially the one on the top passenger side of the engine!!
Check your fuse box....unless you hear it trying to close or open, function whatever... but im sure you have a blown fuse. especially if they stoped working at the same time.
have you had found a solution to your problem as i have exactly the same problem. all i get is the back windows going a little down when i open the catch for the hood
hi there are a couple of invisible screws, look well wich plasic covers you can take away like behind doorgrip.
after that you have to slide the doorpanel upwards.
its not fixed with clips like a lot of other cars but with hooks so slide upwards. after repairing your windowmech. make sure the plastic sheet is replaced very good otherwis you can get water inside the car.
good luck.
×