What is the firing order for 2006 Suzuki Grand Vitara 2.7l 6cylinder

Anand Kumar

• 2035 Answers
• Posted on Jul 15, 2008

SOURCE: suzuki grand vitara 2.0 TDI

This could the problem with onboard computer failure .......

try that after visual check under hood confirms no obvious failures like missing drive belt or disconnected electric wires...

Please mention make code and year of the peugeot engine in the car.....

Good luck....

SOURCE: where is the starter for a 2000 suzuki grand vitara located

starters are normally located at the rear of the motor usually hard to get too or see. should be on your bell housing in other words just in front of the gearbox/clutch

SOURCE: cabin filter element location

Filter is located behind the glove box. All you need is a screwdriver to replace.

1. Open the glove box and empty to take the weight off the box.

2. On the right side there is a plastic hinge like device held on by one Phillips head screw. If you have trouble removing with a Phillips screwdriver you can remove with a narrow flat head screwdriver. Remove the screw and slide hinge off the mount.

3. To drop the glove box press the sides slightly inwards while 'forcing' it open beyond it's normal stopping point. Careful as when it releases it will fall wide open and may even fall from its hinged area. Set it aside.

4. Behind the glove box there is probably some fiberous material inserted to prevent noise like squeaking when it rubs. It is sticky on one side to hold it in place. Just remove and place out of the way.

5. Behind the fiberous material there'll be a cover which kinda looks like a grille. Mine was white and it is in the center of the opening. Remove it by releasing the clips at the left or right. It comes right out.

6. When the cover comes off slide the filter out and replace it. The filter lays flat and just slides in and out easily. However, if it has been some time since you replaced be prepared for a lot of debris on top of the filter such as leaves, grass or other general type of debris that has been sucked into the filter. It also may be the source of any bad odors that you smell through the air conditioning system.

7. Reverse the process. Replace the cover and push the glove box lid back into place. When you replace the glove box be careful to make sure the hinge you initiallly removed the screw from is not left behind the glove box or you will have to remove again to get it out. Replace the screw and do not over tighten as it screws into plastic and then your done.

ZJ Limited

• 17989 Answers
• Posted on May 15, 2010

SOURCE: How to change the fuel filter on a suzuki grand Vitara

Fuel FIlter - Removal

1. Relieve fuel system pressure.
2. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.
   

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.

SOURCE: where is the fuel filter

in front of the fuel tank. above the rear axle towards the passenger side.