2004 was the last year for the montana and it was exactly the same as the 2001. In terms of the tilt lever, they were all the same. Just grab it and pull straight out from the column.
You can use a screwdriver to pry if its too hard. Utube has several videos demonstrating the technique.
SOURCE: can't remove back seats of 2007 pontiac montana
Had same problem with my '04, yank HARD, lol. Warehouse guy walked up, grabbed the cord and bang! up it popped. Good Luck.
SOURCE: 2003 Pontiac Montana Front Wheel Bearings
Remove the wheel, remove the hub nut, remove the brake caliper and rotor, put your socket and extension through the hub flange onto the bearing retainer bolts, undo them, release the abs sensor connector if it has it, remove the bearing and hub flange as an assembly, put the new one on and go backwards from here. Torque the hub nut to 180 ft/lbs, your done.
SOURCE: pontiac montana oil pan bolt diagram for removal
If all the bolts are off, then the gasket is holding the oil pan in place and your going to have to tap it with a mallet, Not a hammer but a mallet so you don not damage the oil pan. Good luck and hope this helps.
SOURCE: 2006 Pontiac Montana wont start after replacing
Sounds like your starter solenoid is stuck in the on position if you can get down there and have some one hook the battery on, hit the starter with a hammer some time this will disengage the starter.
SOURCE: Changing the front brake pads on a 2006 Pontiac Montana SV6
no that is only the older rear calipers on gm and others. the fronts do not have that style caliper and sound like the calipers are frozen and may be way your changing the pads. try opening the bleeder screw and then compressing them if they go then you need need brake hoses and if not you need calipers. god luck man
242 views
Usually answered in minutes!
×