Question about 2008 Chevrolet Hhr
Replace the whole pump assembly while in there, that way everything is new
Posted on May 24, 2019
SOURCE: gas gauge
The float that moves the gas hand is possibly stuck in the tank. If there's isn't an access hole in the rear of the vehicle you'll have to drop the tank. Unless it becomes free on it's own. Hope this is helpful. Please rate. Thanks
Posted on Sep 28, 2008
Youre gauge is controlled by a plunger in the fuel tank which is attached to the sensor and the fuel gauge. it sounds like when the plunger goes down half way its either getting stuck down lower then it should. Needs replacing. Any mechanic can do this install for you.
Posted on Aug 27, 2009
sounds like you probably need a fuel level sender. it's located in the trunk on the right hand side attached to the fuel pump. I got one on ebay for about 20.00, but you might as well replace the fuel pump while you're at it, as it can go bad with time.
Posted on Aug 31, 2009
Fairly common problem with GM vehicles. The sending unit in your tank has a small circuit board that an arm is attached to which moves up and down according to your fuel level. This circuit board and arm are not making good contact. Unfortunately the only good solution is to replace this part.
Posted on Oct 28, 2009
Testimonial: "thought probably that was it but better off replacing whole unit .i was for for gauge proplem thanks. "
Tips for a great answer:
Jan 01, 2016 | 2007 Chevrolet Chevrolet HHR LT
Jan 09, 2015 | 2001 Dodge Caravan
Oct 12, 2014 | 2008 Toyota Yaris
Jan 18, 2014 | 2008 Mazda Tribute
Feb 10, 2013 | Cars & Trucks
Oct 10, 2012 | 2006 GMC Sierra Denali
Apr 15, 2011 | 2007 Subaru Impreza WRX Sport Wagon
Jun 22, 2010 | 2008 Chevrolet Hhr
May 30, 2010 | 2008 Chevrolet Malibu Classic
Apr 15, 2009 | 2003 Chevrolet Malibu
Jan 21, 2018 | 2008 Chevrolet Hhr
72 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: