Question about Dodge Ram

1 Answer

I have an old to Dodge Ram 4.7 L I took the airbag out to change the dashboard put it back in and on my lights on the airbag light and it won't shut off

Posted by Jeff jette on

Ad

1 Answer

Dave Lasky

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 26 Answers

You will probably have to borrow a friends obd reader and reset the fault code.

Posted on May 18, 2019

Ad

5 Related Answers

Anonymous

  • 512 Answers

SOURCE: The airbag light on my 2002 dodge ram 1500 pickup stays on

you need to have it checked out.with the light staying on in an accident the airbag may not deploy. the most likely cause is a bad clockspring but further diagnosis is needed

Posted on Jan 13, 2009

Ad

Anonymous

  • 61 Answers

SOURCE: my srs light had been on

It is my understanding that the SRS is a dealer only reset because it requires a code that is proprietory to MB dealers only. Now, a garage with a good scanner (loaded with applicable MB program) may be able to reset it for cheaper than a dealer. Nonetheless, I do not believe you can reset it on your own.

A side note, as long as the SRS light is on, your airbag and/or belt tensioners may not work if you're in a collision.

Posted on Jan 15, 2009

Anonymous

  • 1 Answer

SOURCE: 1997 Dodge Caravan Horn and Airbag light

It's the " clock spring " . Dodge has a lifetime recall / replacement on this part. Somehow it controls the air bag and is tied into the horn and cruise control .

Posted on Mar 08, 2009

alicantecoli

Colin Stickland

  • 22485 Answers

SOURCE: Flashing dashboard airbag light in 2003 Toyota Avalon

try wiggling wires under the front seats ,if that dont work then take the builb out

Posted on Mar 09, 2009

SOURCE: Airbag dashboard light keeps blinking. In 1997 Ford Thunderbird.

The air bag computer will have to be scanned and the code read to know what the fault the computer detects. The problem will have to be repaired for the light to shut off. Keep in mind, when the air bag light is illuminated the air bag system is deactivated. Meaning, in the event of a collision the bags won't deploy.

Posted on Dec 05, 2009

Testimonial: "Thanks for the input and advice, very helpful."

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2010 Dodge Caliber. We replaced the cv axle shaft and had to pull the hub out and then to a machine shop to have bearing replaced. Put everything back together took it off jacks. Drove it up ramps...


if the recall was done usually will reset on its own have vehicle scanned for trouble code may have nothing to do with recall and if it does bring back to dealer to correctly repair the recall

Aug 30, 2018 | Dodge Cars & Trucks

1 Answer

How do I get the airbag light to shut off on the dashboard?


You take it an have DTC'S checked in the air bag control module . Have it fixed ,then the light will go out . Your best bet is take it to a ASE certified repair shop . You wouldn't want to have an unintended airbag deployment . People have been killed from not knowing what they were doing an setting off an airbag !

Jan 02, 2016 | 1998 Chevrolet Malibu

1 Answer

How to rem ove and install climate control panel 2008 dodge ram 3500


2008 dodge or ram truck ram 3500 truck 2wd l6-6.7l dsl turbo








  • a/c heater control - removal



removal



warning: disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. this is the only sure way to disable the airbag system. failure to take the proper precautions could result in an accidental airbag deployment and possible personal injury or death.






131139774












note: single zone a/c-heater control shown. dual zone similar.





  1. disconnect and isolate the negative battery cable.


  2. remove the center bezel (1) from the instrument panel and disconnect the wire harness connectors (4 and 5) from the back of the a/c-heater control (2) see: body and frameinterior moulding / trimdashboard / instrument panelservice and repairinstrument panel center bezel - removal .



note: take the proper precautions to protect the front face of the center bezel from cosmetic damage.




  1. place the center bezel on a workbench and remove the four screws (3) that secure the a/c-heater control to the center bezel and remove the control.


install------->>>>

installation




131139774












note: single zone a/c-heater control shown. dual zone similar.





  1. position the a/c-heater control (2) into the back of the instrument panel center bezel (1).


  2. install the four screws (3) that secure the a/c-heater control to the center bezel. tighten the screws to 2.2 nm (20 in. lbs.).


  3. connect the wire harness connectors (4 and 5) to the back of the a/c-heater control and install the instrument panel center bezel see: body and frameinterior moulding / trimdashboard / instrument panelservice and repairinstrument panel center bezel - installation .


  4. reconnect the negative battery cable.


assuming this is the correct application for your vehicle, you should be good to go. let me know if you need further assistance.

-tim

autoecu1

800-921-9060

Jan 21, 2015 | Dodge Cars & Trucks

1 Answer

Changed rack and pinion. when turning wheel to right horns started blowing. unplugged airbags and horn stopped. drove truck for 1 day now wont start and dome light is blinking and warning lights on dash...


It sounds like you disturbed the wiring or the connector inside the lower portion (inside the cabin, under the dashboard) of the steering column. You may have also pinched wiring higher inside the steering column, up near the horn button. You'll need to track it all down & correct the wiring problems in (and around) the steering column.

Aug 04, 2014 | 2004 Dodge Ram 1500

1 Answer

Just bought my 2004 Dodge Ram 1500 Quadcab 4x4


use a 1/16 drill bit to drill thru indicator to break bulb. light will not come on when started again

Jan 21, 2010 | 2004 Dodge Ram 1500

1 Answer

Dashboard lights out after replacing headlamp switch..


Did the old switch melt the pluggin? Might be a bad connection on the switch. Or you new switch is defective.

Aug 16, 2009 | 1996 Dodge Ram 1500 Club Cab

3 Answers

Where is the oil sending unit located on dodge ram 1500 v8 gas


Check the back of the top of the block, back behind the intake manifold, in the center.

May 30, 2009 | 1999 Dodge Ram

1 Answer

Air bag light comes on intermdiately


it is the sensor located under the dashboard area. you can buy another one off the internet for 50.00. with instructions on how to remove the old one and then send it back for your deposit back. however, my light also comes on and off when the weather changes. i would ignore it unless it stays on for a few days. all it means is your airbag isnt working. i lived most my life without airbags.

Apr 30, 2009 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Mike

Level 3 Expert

4372 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...