Question about Toyota Cars & Trucks

1 Answer

How do i Reset oil light on a 2007 toyota camry 2.4L?

I'm changing the oil do i suppose to reset the oil light or do it reset itself?

Posted by Joe Russell on

Ad

1 Answer

Kaitano Mpulamasaka

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 22 Answers

Although i have never tried this on camry, but try same procedure for timing belt replace. Set your hold down odo reset nobe, then turn ignition on while still holding it down, when display changes, release and press to match new setting

Posted on May 27, 2019

  • Joe Russell May 27, 2019

    i done reset it about 9 days ago.

×

Ad

5 Related Answers

Anonymous

  • 140 Answers

SOURCE: Reset the maintenance required light on my 2008 toyota corolla

OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..

Posted on Mar 14, 2009

Ad

Toyota Ed

  • 1861 Answers

SOURCE: Transmission oil for toyota camry 1993

1993 Camrys take regular Dexron ATF. It should be changed every 30,000 miles. If you have never changed it, and it is over 100,000 miles, I would strongly suggest a professional "transmission-flush", with a designed specifically for flushing transmissions. To just drain the fluid at this point will leave roughly 3 quarts of dirty ATF in the system; a complete flush will eliminate ny dirty ATF traces.

Posted on May 19, 2009

Anonymous

  • 1 Answer

SOURCE: how to reset 2006 toyota sequoia after change oil

Previous Post dead wrong...

Turn ignition to "ON" position. Make sure odometer is on trip setting not on total vehicle mileage setting.

Turn ignition OFF

Push and hold odometer button while turning ignition to "ON" position. HOld for about 4-5 seconds until maintenance light goes off. Turn ignition OFF. Start up vehicle. There should be no more maintanence light.

Posted on Jun 27, 2009

Anonymous

  • 1 Answer

SOURCE: Hows to reset oil light and oil filter light on 2007 nissan altmi

maintenace and oil filter. i got an oil change last month on my 2007 nissan altima and they did not reset the mileage so the lgiht on the leyboard came on and I cant fix it

Posted on Aug 22, 2009

Anonymous

  • 484 Answers

SOURCE: how to change serpentine belt on 207 toyota camry

4 cylinder diagram
6 cylinder diagram
Loosen the tensioner pulley to remove the belt. It is the one that has a long bolt running through it. Once you remove the old belt, install the new one using the appropriate diagram from the above two links. Readjust the tension using the bolt you loosened to remove the old belt.

i hope this helps
matthew

Posted on Nov 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How To Reset Change Oil Light 2008 Town Country after an oil change.


Hi, the message is supposed to go out when you hold the trip/reset button down for 2 seconds. Please let me know if that doesn't work, and thanks for using FixYa.

Jan 15, 2011 | Chrysler Town & Country Cars & Trucks

2 Answers

Hello today i leaded out my Chevy Suburban truck to my sister she returned to me with the Service Engine Soon light on ?? Im sure she ran the truck up hill ? What might the problem be it was perfect this...


She didn't do anything wrong at all. Your truck is just fine and doing what it was designed to do. That's a normal indicator that comes on to remind you to get the oil changed. It's supposed to get reset every time the oil gets changed and frequently, Quickie Lube and other instant oil change shops will overlook resetting it. Look in your owners manual under "Resetting the Service Engine indicator light" and you can reset it yourself. Or just get the oil changed and tell them to make sure and reset it.

Jan 08, 2011 | Chevrolet Suburban Cars & Trucks

1 Answer

How do i reset the oil change light? 99 grand am se 6cyl


That light should reset itself after you changed the oil .If you have changed the oil and it doesn't reset ,try disconnecting the batter for about 5 mins. check your milage, see how many miles you normally drive before that light normally comes on. That is so, if that light dosen't come on ,you will know its time to change the oil. If that light doesn't come on at the right amount of miles,have your oil changed at the dealer and ask them to check the oil change warning light .If they find nothing wrong ,no charge . This warning light is fairly new ,in the old days people just guessed ,its about time to change the oil !

Jan 05, 2011 | Pontiac Grand Am Cars & Trucks

1 Answer

Maintenance required light on 2008 camry, why is it on?


Hello. Welcome to FIxYa. Please allow us to assist you

The maintenance required light is there to remind you that your oil change is due. This light needs to be reset after the oil ic changed, it is manually reset. If you just had your oil changed, the light will not go off by itself. The light is designed to illuminate after 5,000 miles since the last reset procedure.

Nov 19, 2010 | 2008 Toyota Camry

2 Answers

How to do I reset the maintenance service light on my 2007 Chevy Trail Blazer


there is no light for emissions testing on this vehicle. there is a ses light that can come on, indicationg a problem with the engine or transmission electronic system. this will require a scan tool to pull trouble codes. there is another light called oil life monitoring that needs to be reset after oil changes, which I suspect is what you are seeing. here is a picture of the light and the instructions for resetting.,

The Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL SOON message being turned on, reset the system.
After changing the engine oil, the system must be reset as follows:
  1. Turn the ignition to RUN, with the engine OFF.
  2. Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalization menu.
  3. Press the information button to scroll through the available personalization menu modes until the DIC display shows OIL LIFE RESET.
  4. Press and hold the reset button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
  5. Turn the key to LOCK.
If the CHANGE ENGINE OIL message comes back on when you start the vehicle, the Engine Oil Life System has not reset. Repeat the reset procedure.



485d3b2.gif

Sep 09, 2010 | 2007 Chevrolet TrailBlazer SS

2 Answers

Changed the oil in a 2006 mountaineer but the change oil warning won't go off


You need to reset the oil light using the reset button on the steering wheel. Press the set up button to access the system check mode. press and release the reset button until the display reads "oil life hold reset new". PRess and hold the reset button for two (2) seconds until "if new oil hold reset" is displayed. Press and hold the reset button until "oil life set to 100" is displayed.

Dec 05, 2009 | 2006 Mercury Mountaineer

3 Answers

How to reset check engine light and change oil soon light


You should not reset the ck eng light until you have repaired the problem. Its just going to come on again, unhooking the battery MAY reset it. To reset the change oil light, turn the key on and floor the gas pedal 3 times, that should reset the light.

Nov 11, 2009 | 2005 Buick Century

2 Answers

How to reset the change oil light for lincoln town car 2007


Press setup on message center,
press select for system check,
At oil life, press reset

Aug 14, 2009 | 2007 Lincoln Town Car Signature Limited...

2 Answers

Reset service engine soon light


oil change might not have they obd2 tester to shut
the light go to auto parts chain store like autozone
tell shut it up for you for free

Apr 19, 2009 | 1998 Mercedes-Benz E-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...