SOURCE: 95 F150 wont crank
the starter should be replaced. The solenoid is kikcing the pinion out but there is no contact being made to turn the starter motor. I have the exact same truck and before i changed the starter used the old starter tap trick. Tap the starter casing with a hammer and it should start turning again. hope this was helpful for you. Good luck.
SOURCE: 1998 buick lesabre wont start
Do you have a Chip in the Key? if so that Could be the Problem,Ya see the chip is a resistor and if it looses its ELECTRONIC VALUE in its Case Resistance it wont start to test this Turn the Key in the ON posission then do the Screwdriver thing If it Starts Key is Good and Most Likely the Ignition (SWITCH) is Bad <<ELECTRICAL Side NOY LOCKEST SIDE For More Info Recontact Me
[email protected]<<<<<<<<<<<<<<<
SOURCE: 2001 GMC Sierra, 4.8 occasionally wont start.
sounds like starter solenoid,try cycling the ignition on start on start repeatly but do not go back to the off position off on start will activate the fuel pump repeatly and might flood it,with a faulty solenoid you can usually cycle the ignition repeatly and it will finally engage the starter
SOURCE: 98 Jeep Grand Cherokee - will not start - starter
I also have a 98 Jeep Cherokee with the same problem. I know I probably need to replace the starter eventually but as of now I turn it to accessory only, pop it in neutral, then start it and it works every time when it wouldn't even try to turn over with it in park. Don't know why it works, but it does. Give it a try.
SOURCE: 99 crown vic wont crank when i turn the key
Turn key to the run positio, Press on your brake and run your shifter through the gears a couple opf imes then try starting in neutral. This is for the benefit f the neutral safety switch. If still nothing , Raise the hood and and check the battery for a bad or corroded connection. If all is good, make sure car is in park. There is on the driverside fenderwell a relay that looks like a mine Roun With two small terminals and tw large terinals o opposite ides.. When you turn to crank, you put cirrent to one of the small ter minals and that causes the two large battery cables to connect and give power to the starter. If you can jump the battery side cable and the starter side post the starter will crank if nothing is wrong withe the starter.the two large posts. Use a jumper cable,NOT a coat hanger, iF THE STARTER SPINS THEN START IT WITH THE KEY. Good Luck.. Any more help let me know.
334 views
Usually answered in minutes!
×