How can I remove the wheel and reinstall? I have tried to compress the plastic tabs holding it with a vise-grip players without success
SOURCE: Headlamp assembly on Pontiac G6
well there isn't much on gripping the retainers, what they are, are plastic ball and socket clips. I would lay some tape down underneth the lamp onto the bumper to protect the bumper and then the hard part...while making sure the headlamp is above the bumper, pull with some force on the back half of the light to where it meets with the fender, after a little pulling it should (no promises) should come out, it will seem like it will break but it shouldn't. (I use to work at a body shop and did many of those headlights including my own '06 G6.) Hope that helps.
SOURCE: Replace front license plate holder
On my 92 ford pu, the plastic tabs snap into square holes in the bumper. They can be snapped out when there is no bolt in the hole by using a flat screwdriver & a little prying.
SOURCE: My oldsmobile's hood will not pop open, the cable
TRIED TO REMOVE BOTH BOLTS THE HOOD LOCKE AND OPEN THE WHOLE HOOD & LOCK
SOURCE: Removing calipers from a 1997 T-Bird..
Those bolts should be allen head bolts and NOT torx (star shaped). With a torx bit in that hole all u will do is mess up a torx bit and the flats for the allen wrenches to grab onto. Try using a 10 or 12 mm( cant remeber which it is) allen head wrench.
SOURCE: I need a diagram of the front wheel bearing
These are pressed in. You have to press the hub out first(center part), then there is a C clip that has to be removed to press the bearing out. If you don't have a 20 ton press take it to a shop. Costs about$30.00
42 views
Usually answered in minutes!
×