Check this post from fixya.
http://www.fixya.com/tags/throttle_position_sensor_location/cars/volvo/s40
SOURCE: where is throttle position sensor located on 2000 honda passport
Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.
SOURCE: location of throttle position sensor
the throttle position sensor is located on the side of the throttle body even with the throttle plate.
SOURCE: on a 04 camry with 2.4 ltr engine, can I replace
I think the terms "Throttle Positon Sensor", TPS and "Throttle Body" can be misleading at least in regards to the 04 Camry.
My 04 Camry gave a diagnostic reading of P2121 for my problem "Throttle PEDAL position switch D circuit". However, we changed out the complete Throttle Body/TPS (Toyota Part #22030-0H020) that did NOT fix problem.
The 04 Camry TPS Electronic Module "Throttle Positon Sensor" is factory assembled and riveted to the side of the throttle body. The only way to service/inspect it would be to cut off or drill out the rivets. Not sure you could open the darn thing if you got it off, but that seems to be the only way Toyota sells them!!
Hopefully a new Throttle PEDAL Position Sensor (Toyota Part # 78010-33010 PEDAL ASSY, ACC)
will fix it. This is located under the dash near the accelerator pedal.
So, now I would recommend FIRST to replace the "Throttle PEDAL Positon Sensor" (it is much, much cheaper) and then the Throttle Body/TPS assembly!! Unless of course, you get a diagnostic code as you did for "faulty throttle body!!
SOURCE: need to know location of throttle position sensor
Not 100% sure on your exact car but nissan TPS usually are on the opposite side of the TB from the butterfly return spring.
Testimonial: "thanks a million no information on installing & adjusting in repair manuel"
SOURCE: 1998 jeep wrangler 4.0...trying to
The IAT on your Jeep should be located on the intake manifold, directly behind the throttle body. It will be a screw in sensor with a two wire plug.
?€¢
The throttle actuator motor
?€¢
The throttle position (TP) sensor 1 and 2
The throttle body functions are similar to a conventional throttle body with the following exceptions:
?€¢
An electric motor opens and closes the throttle valve.
?€¢
The throttle blade is spring loaded in both directions and the default position is slightly open.
?€¢
There are 2 individual TP sensors within the throttle body assembly.
Oh yea it has two TPS - throttle position sensors ! An you have to replace the whole assembly !
238 views
Usually answered in minutes!
×