Bontrager 300.how to change /reinstall battery on wheel sensor

this a rear wheel sensor.

Hope this will answer your question,If do pls click on helful botton and you can follow me at fixya,so I can answer your question faster.thanks.

Check the wheel speed sensor it could be dirty with metal shavings or crusted brake fluid not allowing it to work properly

Yes, until you reinstall all your codes, this is the reason mobile battery men have a small battery they connect when they change batteries, to prevent this

tire monitor system has a sensor in each rim. damage to these senors, or replacement of compete rim and wheels without reinstallation of sensors will cause light to come on. if nothing was changed, possible long life battery in tire senors is bad.

Trouble Code: P0344

Camshaft Position Sensor Circuit Intermittent

Possible Causes:


.Wiring harness fault.5v supply circuit open or shorted to ground.Tone wheel/pulse ring is damaged or corroded.CMP Sensor has failed.CMP Sensor signal circuit is open, shorted to ground or battery. voltage or 5v supply.CMP Sensor ground circuit is open.PCM has failed.Trouble Code: P0016

Crankshaft/Camshaft Timing Misalignment

Possible Causes:


.Base engine problem (i.e., the camshaft timing is not correct).Intermittent condition.CKP or CMP Sensor signal is erratic (check with lab scope).Tone wheel or pulse wheel is damaged or contains debris.CKP or CMP Sensor, harness or connector has failed.PCM has failed.Trouble Code: P0061

Engine Temperature Control Level 2 RPM Performance

Possible Causes:


PCM need to be reprogrammed.PCM has failed.

A wheel speed sensor?

They are located at each individual wheel.

An output or input speed sensor?

They are located on the drivers side of the transmission. They are yellowish white in color and look identical to each other. You will need a 1 inch socket to remove and replace them.

The input speed sensor is towards the front of the transmission and the output speed sensor is located toward the rear of the transmission.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Toyotas and Lexus cars have some unique feaures. If your fuel cap is loose or the O2 sensors on the exhaust are faulty this results in an emission problem and the engine computer unit (ECU) engages the check engine light and disables the VSC (the VSC light comes on to warn you that it has been disabled). However you have p0500 code which says the car has no speed sensor signal. The seed sensor is located on the side of the final drive from the transmission and its job is to measure the speed of rotation of the output shaft. The ECU will compare the signals from this shaft along with the speed sensors in the wheel hubs. If there is a difference between these signals the VSC is engaged to apply braking effort to which ever wheel is slipping (running faster) than the other or that the transmission speed sensor would warrant.
So you either have an emission fault has fed back to the VSC and speed sensor missing (p0500) condition, or you have a faulty sped sensor which has tripped the VSC light and in turn the CEL.
Check your fuel filler cap is on tight, turn radio off and disconnect the negative lead to the battery for 5 minutes (this should clear the ECU memory of the code error). If p0500 error and CEL and VSC lights come back on then check the electrical connection to the speed sensor. Ensure it is clean and making a good contact, check the wiring for continuity. If everything else looks good consider changing the speed sensor.

try taking battery off for half an hour and retry

if you are talking about your abs wheel sensors no just make sure you clean everything well

i serviced my 2004 yukon for abs light came on they told me it was the right front abs speed sensor wire , which is sold sepratly or with wheel hub cost$ 300 or 57$ for just sensor wire, i did all brakes changed sensor and for awhile the stayed off but comes on and at about 20 mph it turns off ?