Apparently it comes from the sound system speakers.
https://www.google.com/search?q=2017+kia+sportage+replace+turn+signal+sound+generator
no sound coming from blinkers and door chimes
CarGurus.ca
https://www.cargurus.ca > Cars > Discussion-t66999_d...
This speaker carries all the dash sounds such as seat belt warning, turn signals, reverse cross traffic, welcome sound, etc.
14 answers · 13 votes: Following. My daughter just told me her 2018 Kia Sportage is doing the same thing. Local ...
This car users guide is full of silly beeping , noises.
endless. it seems.
even Using Voice Recognition
Un mute the RADIO yet? kids played with cars knobs?
make sure radio front speaker are not set low via. Front/rear fader set wrong
I guess this is bad.
a cheap speaker here got water into it (gee how can it last there)?)
and died. dead..
top of dash, it pries up./
called by KIA Crash Pad Center Speaker
the system TURNS is complex
it communicates on the CAN-bus network
I found the cluster speaker here in your service manual real
see photo 2 next.
proof is in the pudding./
standard and super vision models both./
i spray the cone paper with clear lacquer and they never fail wet. (CAR SPEAKERS ANY, UNDER ANY KIND OF WINDOW)
what happens is the paper CONE gets damp(no kidding, dah) and
then dries out and paper shrinks and is uneven (and pulls over)
and this bad act moves the VOICE coil over and it jams up
ive restored top end stereo speakers with new cones, many times. and know how they fail.(ROT)
I guess this is also for Voice Recognition
?option?
×
SOURCE: turn signals blink on the wrong side
Do you have a trailer hitch? If you do, the problem may be in the wiring for your trailer lights. I use to work for u-haul and installed $75,000 worth of hitches in one year. the vehicle in your picture take a power module to work your trailer lights. this means a device that takes power from the battery to make your trailer lights work, if you hook up trailer lights to the existing vehicle wiring it will cause a lamp-out sensor failure. If you have this wiring check for normal operation with a test light. If you go to u-haul they probably will inspect your wiring for free. If the device was installed properly, it still can malfunction and probably will sooner or later due to condensation inside the power module. I replaced many of these while working for u-haul.
SOURCE: No left turn signal
CHECK ALL BULBS, SOME HAVE A SLIGHT DARK SPOT ON THE BULB AND IS BAD AND FLASHER COULD ALSO BE BAD. CHECK THE FUSES TOO.
SOURCE: 2002 Hyundai elantra driver side turn signal not working outside
This simply means that the front driver side turn signal bulb has failed. Replace it.
Testimonial: "Thank you I will try that"
SOURCE: how do you reset low tire pressure signal on 2008
Tire Pressure Monitor Systems (TPMS)
Details:
- LINK 1
- LINK 2
You're problem could likely be a problem with the TPMS, or (TirePressure Monitoring System) - sensor. There is one in each wheel, andit's recommended that with any tire changes that they be rebuilt orreplaced. I'm not sure if you've reset the tire pressure switch
Sometimes, to reset the tire pressure light you need to get the special tool.
Hope helped with this. Good luck.
SOURCE: Where is the turn signal relay, hazard relay, and
It is not the flasher if the hazards work, it is 1 flasher for both turn signals and the hazard lamps. It is in a relay block ( along with the blower motor relay ) under the dash, about in line with the steering wheel column ).
Try tilting the steering wheel all the way up, and test again.
The other quick test is to cycle the hazard switch a few times, to see if it cleans the contacts for the turn signal on the MFS,
693 views
Usually answered in minutes!
ok, the sound generator module has failed. how can it be repaired though?
×