Could be a fuel problem. Do a manual pressure check at the fuel rail to see how much pressure you have. Should run about 35 psi.
https://www.clubfrontier.org/forums/f8/fuel-pressure-test-310201/
SOURCE: 2005 FRONTIER 4.0 GOES TO
How are your batt. terminals/battery?? Is it all corroded?? If so, clean battery terminals. Also clean all grounds in engine compartment. There are 2 next to the battery, 2 next to the iol fill hole and 2 next to the air box assy. Check and clean. Is the check engine light on?? If you have a throttle problem, check engine light should be ON. Let me know. Oh and how many miles on it??
SOURCE: limp mode?
It may have a "loss of prime" code that usually follows a service of the fluid and filter. After you're sure the fluid is full at operating temperature, disconnect the battery for a few minutes and reconnect to see if the code resets. I hope this helps.
SOURCE: Had distributor replace vehicle now runnig
the wires could have been place in the wrong positions on the distributor cap. try and see if they are numbered or try moving them into different positions try to i.d.each wire to the correct position with tape or color system and if you get it correct remark them. this is why you change one wire at a time. its is very easy to cross 2 wires some where on the block shoud be the cylinder detonation schedule see if you can match that up to the cap.
SOURCE: Vehicle drving alright then goes
Hello and welcome to FixYa!
You have a new battery right? As a first course of action, please remove the positive battery connector and let it sit for atleast 10mins. Reconnect the positive battery connector and turn the key on ON position then OFF, do this 10 times and on the 10th crank the car. Take it for a few runs and observe how it goes.
Hope this helps and thank you for using FixYa! Have a good one!
SOURCE: 2006 Ford Freestyle wrench light comes on and goes into limp home mode how do you fix
There is no way to get around a proper repair on a computer controlled transmission, that is wishful thinking. What is the fault code that is memory? Have you even run the system scan yet?
61 views
Usually answered in minutes!
×