Question about GMC Cars & Trucks
Did you replace the wiring harness?
Posted on Apr 07, 2019
Did you replace the wiring for the sensor also
Posted on Apr 06, 2019
I really doubt the knock sensor is the problem, check the connector 1st for water intrusion or oil, if u do replace it then u must torque it to the proper spec into the cooling system jacket of the block or it will set another code.
Posted on Mar 11, 2009
the knock sensors are located below the intake plenum,or,upper intake manifold as some call it, they screw into the lower intake, the front one is sensor 1, the rear is sensor 2. it is wise to change both if you have some miles.since you are going to be buying a gasket set to do this job.the sensors are cheaper than the gaskets.
Posted on Jun 12, 2009
SOURCE: 2005 Toyota Camry - knock sensor
Your sensor went off because it overknocked.
Try using a different type of fuel with a higher octane.
Erase the code and use the better gas. if it comes back then we will worry about replacing it.
Posted on Apr 14, 2010
Tips for a great answer:
Mar 25, 2015 | 1996 Chrysler Cirrus
Jul 07, 2011 | GMC Envoy Cars & Trucks
Dec 08, 2010 | 2005 Mazda 6
Aug 03, 2010 | 2001 Ford Expedition
Jul 22, 2010 | 2005 GMC Yukon Denali
Jul 14, 2010 | 2005 GMC Sierra 2500HD 4WD
Feb 05, 2010 | 1992 GMC Sierra
Dec 01, 2009 | 2005 GMC Envoy
Mar 11, 2009 | 2005 Dodge Durango
35 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: