SOURCE: crank no start
SOUNDS LIKE THE CRANK SENSOR POSS. AS I HAVE ONE HERE THAT I JUST DIAGNOSED FOR THE SAME THING WITH A SCAN TOOL WHEN WE FINALLY GOT IT NOT TO START. I'LL FOLLOW UP AFTER SENSOR INSTALL
SOURCE: 93 Jeep Grand Cherokee Won't start
Are you getting spark from coil wire when cranking? If so, check the cap & rotor. If not, the most common failure is the crank sensor. If you have a 4,0, you can find it on the drivers side of the bellhousing, in line with the flywheel, just where it's annoying to work on. There is a test you can make, but I don't have the specific test values or the correct terminals to check. (you can find that info in any half decent manual.
Good luck
SOURCE: 93 Jeep Grand Cherokee Won't start
The crankshaft position sensor was seriously problematic in those old jeeps. It's located towards the top of the bell housing slightly to the driver's side I think.
SOURCE: 97 Avenger will not start!
your coil could have gone out, you could need a new distributor, and your fuel pump could be out. but one thing is the fuses and relays check those as well. there is a relay and fuse for almost anything and that would explain why it all of the sudden happened.
SOURCE: 2000 Chevy 3500 Express Van Cranks but doesnt start
SOUND LIKE INOPERATIVE GLOW PLUGS. THE GLOW PLUG RELAY OR CONTROLLER COULD BE THE PROBLEM.LET DEALERSHIP FIX IT.YOU NEED CERTAIN TOOLS TO WORK ON DIESEL ENGINES.
30 views
Usually answered in minutes!
×