This is after my car was stolen by kids & caught on camera doing donuts & when I got my car back it will only drive in reverse.
Hi, have you tried changing the oil filter? Or check the selector where it goes directly into the box, otherwise the selector inside the "brain" of the gearbox is knackered. Unfortunately the only way to fix it is virtually a full rebuild but I'd definitely check the filter first. Regards, Neil
SOURCE: transmission
Well ,
If the fluid is dark, burnt , or has metal or dark clutch material.
The transmission has a burnt up clutches ,the sun shell in most cases with this transmission is the cause of failure inside.The sun shell holds the clutches and steels in place . When the sun shell breaks the transmission is loosing pressure inside. Then the clutch are not engaging . This is why the transmission is slipping This is a very common problem with this vehicle. The sensors/ soleniods are located in the valve body of the transmision. There are some cases where a transmission shop can tighten the sun shell or bands. This could be a temporary fix, The best thing to do is have the transmission replaced or rebuilt at your local transmission repair shop
SOURCE: chevy avalanche transmission problems
Hello;
Are you getting the check engine light? If so the electronics may have gone out. You may not need a rebuild but you won't know till you pull the oil pan on the transmission and inspect the contents. You may also have lost the neutral safety switch. It is mounted on the drivers side of the transmission. Check those out first and let me know what codes you get.
For Ponchoboy; the clunking and hissing you hear are teminal root causes. Drop the oil pan and if it has a lot of filings and metal it is time for a rebuild.
Hope this helps; Rate me highly;
Rich
RPM Northwest
SOURCE: 1993 Chevy Silverado
Replace the vehicle speed sensor, it's located in the tailhousing of the transfercase
SOURCE: transmission slipping when going from reverse to drive
First thing to check is the fluid level
SOURCE: transmission slipping,dies in drive
Hi there.Hope this can help.On the top of the transmission there's a black electrical plug that the shift linkage goes in..It sounds like the range sensor is out of adjustment..If you try going from reverse to like first or second does it still stall.You may have to get it adjusted.Does the selector in the car where it say P R N D 2 1 Line up with its indicator.
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
199 views
Usually answered in minutes!
×