- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The turn signal and hazard flasher unit is located in the interior fuse
panel located under the driver's left side knee protector. They are
replaced by simply pulling them straight out. Note that the prongs are
arranged in such a way that the flasher must be properly oriented before
attempting to install it. Turn the flasher until the orientation of the
prongs is correct and simply push it firmly in until the prongs are
Hope this helps (remember to rating this free answer).
When you have electrical problems like this , it is best to have a schematic on hand. you will have to purchase a manual. there are no free ones online. If it were mine I would remove the fuses block to get to the wires on the back side, find which two went to the headlights ,pull them out and put in a inline fuse. you can replace the whole block, get one at a salvage yard, cut enough wire to give yourself room to work. this very time consuming. Also I have worked on other vehicles and found that the light switch itself was overheating and would loose contact inside the switch. I can't say that I've replaced one in your type of car, But I wouldn't rule it out.
looked it up online, looks like its in the underhood fuse box but couldn't get a good diagram that shows which relay number it is. the website i use is sort of dependent on the manufacturer, apparently acura did not feel like sharing that info. hope that helps
The thermal flasher is sometimes on the fuse panel. The fuse panel is usually located on thelower part of the console just to the left of the drivers Knee. There will be a detent on the panel where you can pull the panel off.
replace de ignition module first.. if still wont start good chances is the crank sensor is located behind the timing belt.. my 94 legend use to do the same thing until i replace the crank sensor.. and also if u can afford i will suggest u to replace the main fuel relay too... all this is after u are 100 pcnt sure that ur fuel pump is working....