Service engine soon light code flashes once then twice then one then twice
Couple things to check. Most commonly that light is from a loose gas cap. Try taking it off and putting back on. Then to clear the code try the following:
key in, wait 3 seconds, press accelerator 5 times, wait 7 seconds, hold accelerator for 10 seconds
Try it a few times and see if that clears it.
Next check air filter make sure it's clean, replace if needed then use above method to clear light
Hopefully that works if not you'll need an OBD2 scanner to get the code ...it's likely something in EGR, a sensor.
SOURCE: 'service engine soon' light
HI
without using the scan tool you can do it by disconnected the the battery for ( 24 h) to reset it or to ( 5 m) to reset the service engine light but the fault sty in the memory
WITH MY BEST WISHES
SOURCE: flashing light on dashboard 98 dodge neon service engine soon light on
11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking for dodge odb readout. Hope this helps.
SOURCE: Service Engine soon light Code P0133
I just came from an Autozone, and then spoke with 2 Hyundai dealership service departments and they all three stated the P0113 code is the Intake Air Temperature sensor (IAT, also referred to as the Mass Air Pressure - MAP - sensor) on the engine, not an O2 sensor found in the exhaust system.
SOURCE: Service engine soon lights on (Nissan Quest 2007)
This is most likely the O2 Sensor however, that light may also come on for a vacum leak or anyone of a number of other sensors. Take the vehicle to Auto Zone and ask them to use a code reader on it and tell you what the code is for. If the code is for O2 sensor as I suspect the part will cost about $40 and take maybe 20 minutes to replace your self. ($40 for part + 5 to 10 for the special socket) If it shows anything else you may want to take it to a mechanic to have the vehicle diagnosed.
SOURCE: nissan frontier 2002 failed emissions test with
CODE PO447 EVAP CANISTER VENT CONTROL VALVE CIRCUIT OPEN.POSSIBLE CAUSES. 1.HARNESS OR CONNECTORS THE SOLENOID VALVE CIRCUIT IS OPEN OR SHORTED. 2. EVAP CANISTER VENT CONTROL SOLENOID VALVE.
235 views
Usually answered in minutes!
×