Location of fuel pump 1989 Chrysler Maserati - Chrysler Cars & Trucks

SOURCE: location of fuel pump relay on a 1989 Chrysler new

Open hood and on left fender are there are 3 relays. The first one toward front of car is the ASD relay or fuel pump relay.

SOURCE: where is fuel pump relay on 1989 chevy suburban 1500

passengers side firewall behind plastic cover thats about 12 inches long with a bump in the middle,where the battery cables hook together ,there should be 2 relays there and i think its the one closest to the drivers side

SOURCE: location of fuel pump relay

should be under the hood on the drivers side

Duane Wong

• 6826 Answers
• Posted on Oct 07, 2010

SOURCE: how do you change a

I couldn't find a 1989 Chrysler Cirrus, but is it a 1999 Chrysler Cirrus?

If so:

Cirrus, Stratus, Sebring Convertible and Breeze The fuel pump is serviced as part of the fuel pump module. The fuel pump module is installed in the top of the fuel tank and contains the electric fuel pump, fuel pump reservoir, inlet strainer fuel gauge sending unit, fuel supply and return line connections and the pressure regulator. The inlet strainer, fuel pressure regulator and level sensor are the only serviceable items. If the fuel pump requires service, replace the fuel pump module. CAUTION
Fuel injection systems remain under pressure, even after the engine has been turned OFF. The fuel system pressure MUST be relieved before disconnecting any fuel lines. Failure to do so may result in fire and/or personal injury.

1. Disconnect the negative battery cable from the left strut tower. The ground cable is equipped with an insulator grommet which should be placed on the stud to prevent the negative battery cable from accidentally grounding.
2. Remove the fuel filler cap and relieve the fuel system pressure, as outlined earlier in this procedure.
3. Raise and safely support the vehicle.
4. Drain and remove the fuel tank, as outlined under the Tank Assembly removal and installation procedure, later in this section. CAUTION
   Observe all applicable safety precautions when working around fuel. Do not allow fuel spray or fuel vapors to come in contact with a spark or open flame. Keep a dry chemical (Class B) fire extinguisher near the work area. Never drain or store fuel in an open container due to the possibility of fire or explosion.
   
5. Clean the top of the tank to remove any loose dirt.
6. Disconnect the fuel lines from the fuel pump module by depressing the quick-connect retainers with your thumb and forefinger. Fig. 3: Removal of the fuel pump module lock ring using the special tool
   
   
7. Using special tool 6856 (Fuel Pump Module Ring Spanner) or equivalent, remove the fuel pump lock ring. WARNING
   The fuel reservoir of the fuel pump module does not empty out when the tank is drained. The fuel in the reservoir may spill out when the module is removed. Fig. 4: Carefully remove the fuel pump module from the fuel tank
   
   
8. Remove the fuel pump and O-ring seal from the tank. Discard the old O-ring seal. To install:
   
9. Thoroughly clean all parts. Wipe the seal area of the tank clean. Place a new O-ring on the ledge between the tank threads and the pump module opening.
10. Position the fuel pump module in the tank. Make sure the alignment tab on the underside of the pump module flange sits in the corresponding notch in the fuel tank.
11. While holding the fuel pump module in place, install the locking ring and tighten to 45 ft. lbs. (61 Nm), using special tool 6856 or an equivalent spanner-type tool. WARNING
    Do not overtighten the pump lock ring, as this may cause a fuel leak.
    
12. Install a new fuel filter.
13. Raise and install the fuel tank assembly, as described later in this section.
14. Carefully lower the vehicle.
15. Connect the negative battery cable.
16. Refill the fuel tank with clean fuel. Turn the ignition switch to the ON position to pressurize the system. Check the fuel system for leaks.

SOURCE: location of relay and fuel

The fuel pump is in the fuel tank. The tank must be drained and removed to change it. the fuel pump relay is on the passenger side of the engine compartment. It is to the outside of the right shock tower next to a large fuel pump solenoid resister.

FYI: the circuit opening relay is in the passenger's kick panel fuse box. The EFI main relay is in the engine compartment fuse box.