SOURCE: need to know what the warning light on dash means
The flashing dash light is a warning about a failing system, most likely the fuel system. On mine it was the oxygen sensor on the way out. You need to do the diagnosis process with the ECU and this will report back the code that will tell you precisely what's the problem. You'll find the ECU diagnosis procedure here at the 300ZX online factory service manual.
Hope this helps.
SOURCE: SEAT TOLEDO WARNING LIGHTS
Could be the motor-management-warning light, but I guess it's the break-warning light. There might be too little breaking-fluid left in the lines ... A boardcomputer-readout should clarify this.
Otherwise, try parking on an ascending road with the nose pointing up, hit the hand-break and wait like 2 minutes; the light should come on. You might wanna retry it with the car's nose pointing downwards as well ... If so, definitely the breaking-fluid, otherwise probably not ;)
In any case - flashing warning light are never ok, so when you see it again and you're sure it's not just the ABS/ESP warning light, go and have your boardcomputer read-out, since it should contain useful errorcodes ..
SOURCE: Warning light on dash - need to know what it means
if it look like this http://www.postimage.org/Pq8RFN0.jpg its the esp light it means you have a fault relating to that system.you need to get a diagnostic check done,there is nothing you can do i,m afraid its a dealer or specialist job.
SOURCE: warning light with triangle with exclamation mark
The waring kight with the triangle and exclamation mark is waring you that the brake pads are close to tuoching the disc's the waring sensor on the brake pad has shorted. It's so you do not scrap the disc's.
SOURCE: triangle with car and skid
{: ) These triangles you saw is for the Stabilitrak (traction control) indicators. Normally these lights should be off after the engine has started, unless you disable it by pressing the stabilitrak button. Sometimes it lights up automatically when driving under certain road conditions, and will turn off later when normal conditions resume. A wrench beside the triangle indicates a fault is detected on thge traction system and it requires servicing.
What you can try, stop the vehicle, turn ignition off for a few seconds to reset the system, and then restart the vehicle. If the lights wont go off, then tghe vehicle really needed to be checked right away.
400 views
Usually answered in minutes!
×