SOURCE: 2002 CHEVY TRAILBLAZER LICENSE PLATE LIGHTS(2)
there is none, will have to replace lights, should came on with running or parking lights.
SOURCE: license plate light replacement
The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.
SOURCE: program a new key fob for a 2002 chevy tahoe
1. Close all vehicle doors.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold
down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without starting the
engine).
6. Turn the ignition switch to the OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock
the doors automatically.
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until
the door locks and unlocks.
This step may take up to 30 seconds.
11. Repeat step 10 NOW for each additional transmitter (including any existing
transmitters).
12. Turn the ignition switch to the ON position in order to exit the transmitter programming
mode.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: 1989 Cheyenne parking lights, dash lights, lic plate light out
could be bad headlight switch
SOURCE: changing license plate lights on 2004 chevrolet
the light can be replaced from the back side of the light housing . go under the back side of bumper under the truck behind lisence plate you will see the where the wire goes to the light . grab the housing not the wires and twist about a half a turn and pull gently. it should come out and then remove the light bulb and replace with new
113 views
Usually answered in minutes!
×