Question about Honda CRX
SOURCE: 2002 Honda Accord Power Window
the regulator has stuck /the cable may be pinched in the arm /other than taking the door apart that is the only way/ Please rate my response thank you very much
Posted on Jan 31, 2009
Sounds like maybe some pin switches for interlocks have gone bad. Open your trunk and look for the rubber booted switches and try holding them or shorting them, if you make the top move it shows you which ones are bad.
Posted on Jul 16, 2009
SOURCE: honda crx electric roof fault
I dont know wether you have managed to solve your problem with the roof yet, but I have tried sorting out a simular problem. First off all if you need to reset the computor in the boot , to do this remove the 7.5 amp back up fuse under the bonnet for approx 10 seconds. before doing this make sure all locks are in the closed possition. Also make sure the roof mechanism is fully down. Once the fuse is back in and the key is in the ignition the car will go into diagnostic mode for the boot and roof.
The easy way to check the roof locks is to open passenger side and see if the car starts to beep if so close the lock and the beeping should stop this shows all is ok. Now do the same on the drivers side.After doing these checks you will need to reset the computer again with removal of the 7.5 amp fuse for 10 seconds.
Its worth checking the 20 amp fuse for the power door locks this fuse is under the dash board.
I hope this is some help.
Posted on Jul 18, 2009
SOURCE: sticking roof
This symptom almost always points to a lubrication issue. The SLK hardtop is notorious for needing to belubricated every couple of years. Here is a link with directions andphotos:
Posted on Aug 17, 2009
Tips for a great answer:
Jun 12, 2014 | 1997 Honda CRX
May 09, 2013 | Cars & Trucks
Jun 29, 2012 | 1991 Honda CRX
Apr 07, 2012 | Honda CRX Cars & Trucks
May 20, 2010 | 1991 Honda CRX
Apr 11, 2010 | Honda del Sol Cars & Trucks
Jul 16, 2009 | 1999 Mercedes-Benz SLK
Jun 05, 2009 | 1994 Honda Civic Del Sol
52 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: