SOURCE: 4M40 engine lacking power and blowing black smoke.
http://www.delicaclub.com/load.php?id=20
Install the egr mod, will stop it smoking in no time
Delica owner...
SOURCE: pajero 4m40 2.8d turbo
in front of the deisel pump the gear wheel is slightly cut/chip mark to the back of it take it out, and place it on t or n (t for turbo n for non turbo) .normal timming is good .If not hand turn until #1 piston is up and #1 cam shaft lobes are not touching cup & shim then set pump to desired mark
SOURCE: WIRING DIAGRAM FOR TOWBAR ELECTRICS WOULD EXPECT
Hi There.
here are the 7 cable locations and pin numbers.
Pin 1 Yellow L/H Direction Indicator
Pin 2 Blue Rear Fog Lamps
Pin 3 White Earth Return
Pin 4 Green R/H Direction Indicator
Pin 5 Brown R/H Tail & No, Plate Light
Pin 6 Red Stop Lamps
Pin 7 Black L/H Tail & No, Plate Lights
I found the easiest way to locate the correct wires in the loom is to turn on the lights required and use a circuit tester and splice into the main loom where you have enough wire to play with. Try not to cut the loom as it only causes more problems with bad connections and joins.
Good Luck
Mitsubishi uses little dots for timming marks and usually line up with other dots one the head or block.
SOURCE: delica 1997 with 4m40 engine and electronic pump. need wiring diagramme
my delica 1998 starts but shutdown right away again.can't find the problem can anyone help me?
324 views
Usually answered in minutes!
×