Https://www.sparkyexpress.ca/blogs/auto-blog/nissan-wheel-lug-nut-torque-chart
85 lb feet is your answer
Is he looking for the wheel lug nut torque or the wheel hub mounting bolts torque? I took it was the hub bearing nut torque he wanted. Now I think it is the mounting bolts which are 65 lbs to 88 lbs torque. https://dannysengineportal.com/wp-conten...
×
120-130 ft lb
Are you sure it's 120 ft-lbs? That seems awfully high. Just to make sure we are speaking of the same bolt its a 17 mm and there are 4 of them (2012 Nissan Rogue SV AWD)
http://caissiedrive.net/abw/SKF_Torque_S...
SKF Torque Specification Guide Page 21 torque 92-125 AWD Rogue
Yes hub bearing nut torque.
×
SOURCE: Front Hub Bearing Torque specs to complete replacement
THE LUG NUT TORQUE SPEC - 140FT/LBS\
CALIPER MOUNT - 80FT/LBS
CALIPER BRACKET 129FT/LBS
AXLE NUT 177FT/LBS
SOURCE: Replacing front wheel hub assembly on 2006
Caliper mount bolts are 74 ft/lbs
Driveshaft axle nut is 177 ft/lbs
Hub and bearing mounting bolts are 133 ft/lbs
Testimonial: "The info on the torgue specs was very helpful. I couldn't find it anywhere. Thanks a bunch!"
SOURCE: what is the torque specs for a hub and bearing assembly on a 2001 four wheel drive chevy s10 blazer
Adjustment
The wheel bearings on these vehicles are not adjustable. If the bearings become loose or make noise, they must be replaced.
Removal & Installation
NOTE
Lay the hub and bearing on the wheel studs on the outboard side. This will avoid damaging the bearing seal.
Tire and wheel
Caliper, leaving the fluid lines connected
Brake rotor
Halfshaft from the hub and bearing on 4WD vehicles. Place a brass drift against the outer edge of the halfshaft to protect the shaft threads. Use a hammer to sharply strike the brass drift, but to do not remove the halfshaft at this time.
Wheel speed sensor
Wheel hub and bearing-to-steering knuckle bolts and hub and bearing
Splash shield from the steering knuckle
Seal from the hub and bearing
To install:
Wheel hub and bearing seal
Splash shield to the steering knuckle, making sure it-s properly aligned
Hub and bearing to the steering knuckle, aligning the threaded holes
Hub and bearing bolts and tighten to 77 ft. lbs. (105 Nm)
Wheel speed sensor. Tighten the bolt to 13 ft. lbs. (18 Nm).
Rotor and brake caliper
Tire and wheel
The Hub Bearing Torque - Front
If Torque Specs are not in the box we recommend youtorque to this setting. Axle Nut: 103 Ft/Lbs.Flange Bolts: 77 Ft/Lbs. WARNING: Failure to observe the following warningscould create a risk of death or serious injury.Proper maintenance and handling practices arecritical.Always follow installation instructions and maintainproper lubrication.Every reasonable effort has been made to ensure theaccuracy of the information contained in thiswriting, but no liability is accepted for errors,omissions or for any other reason.This information is not intended to substitute forthe specific recommendations of your vehiclemanufacturer.Always use the recommended torque requirement unlessotherwise specified in the carton.Depending on the application, type of hub unitbearing and location, the installation process mayvary.Please review the vehicle manufacturer'srecommendation before removing or installingcomponents.
4,059 views
Usually answered in minutes!
×