Sir Would you email the nearest Diagnostics Centre for my Daewoo Nubira 1998 model. I am residing in Daveyton near Benoni town in Gauteng East. My car shows warning light on dash board. I have recently replaced the oil pump, but still showing. It have also replaced tensioner three times in less than six months. Timing belt was replaced in February 2018. Please advise. Patrick cell 076 890 8132
SOURCE: timing marks for a daewoo nubira cdx
Here is a pic if the timing marks two small marks on the cam pulleys and one small cut away on the crank pulley .
SOURCE: replacing timing belt on daewoo nubira 2000 model
Instructions
Difficulty: Moderate
Things You’ll Need:
Step1
Raise and support the vehicle
on jack stands. Remove the intake air temperature wiring, the breather
hose and intake air hose. Take off the air cleaner assembly.
Step2
Remove the right wheel. Remove the accessory belts. Remove the
crankshaft bolt and the crankshaft pulley. Remove the power steering
bolts and the timing belt covers. Temporarily install the crankshaft
bolt and turn the engine clockwise until the mark on the crankshaft
pulley, which is a triangle stamped into the crank sprocket, is aligned
with the corresponding triangular mark on the block.
Step3
Make sure that the timing marks are aligned on the camshaft sprockets.
These are a line on each sprocket that runs through a tooth on each
sprocket. These lines should line up in the middle between each
sprocket and point toward each other. If they do not line up, turn the
crankshaft one more time and they will line up. It takes two turns of
the crank to one complete revolution of the cam.
Step4
Loosen the water pump bolts; using the 3/8-inch ratchet, turn the water
pump clockwise away from the belt and loosely tighten the bolts to keep
it there. Remove the timing belt.
Make sure the timing marks are aligned and install the new belt
starting on the right side from the crank sprocket and working
counterclockwise. Keep all the belt tension on the right side away from
the tensioner.
Step5
Loosen the bolts in the water pump and rotate the water pump
counterclockwise to apply tension to the belt. Watch the tensioner,
which is above the water pump, and apply tension with the water pump
until the pointer on the tensioner lines up with the notch above it.
Lightly tighten the water-pump bolts.
Step6
Turn the engine
two more times and align the timing marks perfectly. Loosen the
water-pump bolts and, using the ratchet, apply tension to the belt
until the tensioner pointers are aligned. Tighten the water-pump bolts.
Step7
Install the timing-belt covers and the bolts in the power-steering pump
and tighten. Remove the crankshaft bolt and install the crank pulley
and the bolt, then torque the crankshaft pulley bolt to 70 foot pounds
of torque. Install all components in reverse order of removal.
SOURCE: engine oil light is showing on the dash board after switching on
Most important thing you need to do is to establish the actual oil pressure. put a mechanical gauge on the engine and read real oil pressure. If pressure is low (min is 15psi, I prefer to see at least 20 at idle) there is an internal problem...bearings etc. If pressure is good, sending unit has failed...replace it. I would not drive it 'till the oil pressure is verified as being safe. You might get lucky and someone just forgot to plug in the sending unit, but it must be checked!!!
good luck
SOURCE: Newly replaced timing belt was broken in my daewoo nubira 2000
Yes you should always do the water pump when doing the timing belt. belt tension too tight can cause the break as well as a bad water pump or idler pully, these should all be replaced when you do a timing belt to save yourself this exact headache later on.
SOURCE: replacing timing belt on daewoo nubira 2000 model
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/2000/make/daewoo/model/nubira/2000_daewoo_nubira_timing_belt_diagram_marks.htm
41 views
Usually answered in minutes!
×