I just bought a 2010 Cadillac STS. I'm trying to figure out how to program the memory seats. The car does not have the original radio, and there are no program buttons on the driver's door.

SOURCE: setting memory seats on 1997 grand cherokee with key fob

I had the same problem and had to kinda figure it out on my own. I have a 98 grand cherokee and I think they should be the same. Inside the drivers door panel there are 3 buttons... a number 1 and number 2 and a SET button. Hold down the set button for a couple seconds then release. Then adjust your settings on your seat and mirrors to what you want...Then press # 1. If you have another person that will be driving the car do the same and press number 2...

The thing is...........There are 2 key chain things issued with each car...One will be the number 1 driver, the other one is the number 2 driver...So...I would program the number 1 driver first and see which key chain thing works...then you will know the other one will be for the number 2 driver.

Hope that made sense...It is a great feature once you finally figure it out. Sheri

SOURCE: Car will not unlock.

To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

SOURCE: How to set memory on seats

adjust seat and steering to comfortable position press set and 1 on drivers door,position will be put into memory. put seat and steering into position that it is easy to get out of car, press exit 1 and the exit position will be in memory. do same procedure for driver2.

SOURCE: How do I program my

that is a dealer item there-that is serious,call them for advise 1st-they should help you w/ no charge
thats an sts we're talkin about

SOURCE: I have suddenly several issues with my 2003 chevy

Hello....have it re-flashed with the updated software at a dealer....you might try removing the seat ckt breaker located in the left IP fuse block for a few seconds,or just unhook the battery for a few minutes to see if it resets itself...sometimes that will work.

Here is the GM bulletin issued for this problem:

#PIT3598: Power Seat Switch Works in the Opposite Direction - keywords AN3 driver electrical intermittent memory module move operation recall reverse RKE - (May 26, 2005)


Subject: Power Seat Switch Works in the Opposite Direction


Models: 2003-2005 Cadillac Escalade, Escalade ESV, Escalade EXT

2003-2005 Chevrolet Avalanche, Silverado, Suburban, Tahoe

2003-2005 GMC Sierra, Yukon, Yukon XL, Yukon Denali

with Seat, Front Individual (Non BKT) (RPO AN3)

2003-2005 HUMMER H2

with Seat, Front Bucket Deluxe (RPO AR9)

Good luck---I hope this helps.