I replaced the computer at 120,000 miles, did not affect the operation of the cruse control which was working before and after computer replaced. Any fix ideas? Thank you
SOURCE: 98 chevy k1500 cruse control
Hi,
Appreciate the "Ask Me".
To my knowledge, Cruise Control would be relatively difficult to diagnose without a scan tool attached to the control module to read the error codes. Additionally, car versions in my country seldom have such a device since our roads are narrower and travel distance is not that great.
Though most known causes are:
Other possible components to check are:
As posted above, quite a number of possibilities. Any other indications, speedometer OK; abnormal throttle responses; abnormal idling, brake light always ON, slack in the accelerator/gas pedal? Was it cutting in/out before? Was there any recent repair work done on the engine before the cruise control cut out?
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
SOURCE: power door locks on a 2004 chevy tahoe don't work
The door locks on my 1999 tahoe stopped working and I checked the fuse, which was fine. The problem turned out to be that the fuse for my cigarette lighter was bad and for some reason it also must be working in order for the door locks to work. Put in a new cigarette lighter fuse and the door locks worked again!
SOURCE: driver side power seat 2001 Chevy Tahoe
as long as nothing is stuck in track and you hear no noise when using switches, look for broken wire at connector or in harness. ck fuse first of course, if blown, something may be stuck in track causing it to stop and blowing fuse
SOURCE: no power to starter 2004 chevy tahoe
Hi
It could be your neutral safety switch. It could be the starter relay which is located in the fuse panel box. It could be the smaller wire going to the starter could be loose or corroded.
282 views
Usually answered in minutes!
×