Question about 1994 Jeep Wrangler

Open Question

WHAT FUSE CONTROLS VOLTAGE METER,GAS GAUGE,SPEED RECORDER,FAN MOTOR FOR 1994 JEEP WRANGLER.

Posted by cedric crews on

Ad

5 Related Answers

Anonymous

  • 4 Answers

SOURCE: Jeep wrangler Fuse box

i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck

Posted on Jun 30, 2008

Ad

Anonymous

  • 16 Answers

SOURCE: Jeep wrangler Fuse box

You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.

Posted on Jan 10, 2009

Ad

Anonymous

  • 124 Answers

SOURCE: how to change starter on 1994 jeep wrangler

is it the straight six? if so first disconnect the battery then there should be 2 bolt 13 or 14 mm. take wires off. then reverse for install.

Posted on Mar 11, 2009

Anonymous

  • 108 Answers

SOURCE: 2005 Crown Vic climat contr fan not working Fuses good Motor good

does it have a digital control panel? As this uses an electronic blower speed controller located at the engine compartment (rear engine block) fix on ac phlenum try to shake the connector or wire while the system is on.

Posted on Jan 31, 2010

Anonymous

  • 306 Answers

SOURCE: 2001 Jeep Wrangler heater blower stopped working

Yes I would go with the switch, BUT, does it have a resistor bank? That is, how does it reduce the speed? Many systems use resistors to lower the speed. Burnt or bad connections can cause this as well.
You can test the blower motor by connecting direct power from a source like the cigarette lighter if you are handy.
Most of the time the lower speeds konk out but the high speed continues to work this is the resistor bank that goes out.

Posted on Mar 25, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 jeep wragler sport 6cyl battery good and holds charge, changed starter, drove about a mile and battery gauge shot up to 19 volts, went back down to normal then shot back up to 19, what do you think is...


use a digital voltage meter on the battery to verify the 'spikes', Jeep Wrangler gauges are notorious for being erratic (I have a 98 TJ, how's your gas gauge working?)-

the printed circuit board gets weird due to water leaks that find their way to the back of the pod from the top of the roof seal, so it is not unusual for gauges to act strangly.

If that is not the case, it is time for a new alternator.

Mar 14, 2011 | 1997 Jeep Wrangler

1 Answer

How do i get my blower motor on 1994 jeep cherokee to come on?


If you put the control inside the vehicle on and the blower does not come on first check the fuse for the blower circuit, next check to see if you have voltage on the motor terminals...if no volts then you can check the resistor block on the air plenum(these things go bad all the time) the block controls the different speeds for the motor..if you have voltage on the blower motor then the motor is bad...no voltage then may be resistor block or switch inside cab.

Dec 08, 2010 | 1994 Jeep Grand Cherokee

2 Answers

2001 Jeep Wrangler heater blower stopped working


Yes I would go with the switch, BUT, does it have a resistor bank? That is, how does it reduce the speed? Many systems use resistors to lower the speed. Burnt or bad connections can cause this as well.
You can test the blower motor by connecting direct power from a source like the cigarette lighter if you are handy.
Most of the time the lower speeds konk out but the high speed continues to work this is the resistor bank that goes out.

Mar 25, 2010 | 2001 Jeep Wrangler

2 Answers

I have a 1999 Jeep Wrangler and the heater fan stopped working for all the fan speeds. The fuses are fine. How do you know if it is the blower resistor or the blower motor?


If you bypass the resistor pack and connect the motor directly to the fused 12v supply then the fan should run at maximum speed. If so, it's the resistor pack that's blown: a very common fault on a huge number of makes and models.

Feb 13, 2010 | 1999 Jeep Wrangler

1 Answer

1997 jeep wrangler se,fan for a/c and heat quit.all fuses seem good.any other relays or switches jeep have had probs with?


If it only works on Hi, then your resistor is blown. If you can pull the connector to the blower fan and use a voltage tester to find voltage there with the fan switch turned on then it's the blower motor. If there is no voltage there, then its the switch on the dash. Usually the resistor and the switch only die because the blower motor is about to die and is pulling more current then it's supposed to. Change the blower motor too if that's the case.

Jan 10, 2010 | 1997 Jeep Wrangler

1 Answer

No spark


Do a code check. If you can't, use a good volt/ohm meter to check components...I'd look at the ignition coil, crank sensor ign control module and all ignition related fuses. Most inexpensive manuals cover this stuff.

Mar 09, 2009 | 1994 Jeep Wrangler

1 Answer

Dash lights don't work


did you check for loose connections in the wiring harness, fuse box, or fuses?

Jan 12, 2009 | 1992 Jeep Wrangler

Not finding what you are looking for?
1994 Jeep Wrangler Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...