SOURCE: Replace Timing Chain for 2003 Honda CRV?
Rule of thumb this is a timeing belt and it should be changed every 75,000 mile as a general practice. I hope this helps, dont forget to rate my answer, thanks
SOURCE: Door panel removal from 2005 Honda Accord
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 2003 ford thunderbird how do you remove inner door panel?
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: My 2003 Honda CRV ...drivers side door does not
you may need to replace the door locking actuator, they do tend to go bad over times. does the driver side door lock automatic when using the lock button on the driver side. if you can lock and unlock the driver side door with a switch, my guess would not be the locking actuator, it might be in the remote locking module.
Testimonial: "Thanks for the help. everything relates back to the actuator.."
SOURCE: 2003 honda civic how to remove door panel
Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.
Pop out the door handle, and unplug the power lock plug,
Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.
next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)
Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)
Unplug power window connector (big green plug)
Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas
147 views
Usually answered in minutes!
×