SOURCE: 1998 528i bmw cam shaft sensor location
hope this helps .
http://picasaweb.google.com/mmm635/CamshaftPositionSensorsCamshaftPulseGeneratorsAsBMWCallsIt#
not the same year but should be same place.
SOURCE: Cam Shaft Position Sensor 1998 Saturn SL
Have a look at this link, scroll to your engine & click on picture to expand for better view.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904
SOURCE: Need to find Camshaft position sensor and crank se
CRANKSHAFT SENSOR - Under hood, center, front engine area, rear of crankshaft pulley, mounted in timing cover assembly.
CAMSHAFT SENSOR - Under hood, passenger side, upper engine area, mounted on engine in front of camshaft.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: Where is the cam shaft position sensor located?
It's not that hard to replaced, and can be done with common tools.
3.4 camshaft sensor removal:
Remove the serpentine belt, Disconnect the sensor wire harness, Remove the power steering pump (just remove it from the mount and out of the way), Remove the attachment bolt to the sensor, Remove the sensor, (note spray around the sensor with brake parts cleaner before removal to keep dirt from entering the engine)
To install:
Lubricate the new O ring with engine oil before installing the new camshaft sensor, Tighten the retaining bolt to 8 ft.lbs. connect the sensor's electrical wire, reinstall the power steering pump, reinstall the serpentine belt.
Start the car and go out for the night with the money you just saved, You can pick up the camshaft sensor at Auto Zone and they can also give you the step by step instructions to getting the job done. Good luck and hope this helps. Take's just under 1 1/2 hour to do. You can do it in under 1 hour though if your good with tools.
SOURCE: where is backup light switch located on 2006
You didn't say if this vehicle was Automatic Transaxle or Manual Transaxle. No need
here are two photos: One is Manual, the other is Automatic. The manual trans has a separate switch (all by itself), however, the automatic (of both the 4 cylinder and 6 cylinder) use the trans range switch to provide power to the back up lamps
Hope this helps
1,101 views
Usually answered in minutes!
×