SOURCE: i have 2003 grand cherokee crd,it has a leak
was the seal lubricated with Vasoline uopn installing it? If not scoring the seal will be done causing a nick or cut so you get this leak
SOURCE: 2006 Cherokee KJ 2.8 CRD intermittent problem.
fuel pump relay . you should hear the fuel pump run for 5 seconds as soon as you turn the key on .after that the cranking sensor takes over when engine it turned over to start
Testimonial: "Great response time. Will further advise when relay is replaced."
SOURCE: 2004 Jeep Grand Cherokee CRD 2.7L injector seal leak issue
I would contact the dealer and see if the parts dept has a revised seal.
have the fault codes read and replace the faulty units. Ask the service person if they pressure cleaned the engine as that quite often causes problems with water getting into the connections and shorting out
SOURCE: 2002 Jeep Cherokee 2.5 crd no injector pulse
outside USA this Cherokee is Liberty.
but is not our liberty. (fun no?) or Cherokee ended in 2001.
of your 4 post, this wins the ," title best post."
the IMMO lamp is on; SKIS/M lamp.
sorry, you need to scan the PCM to see why.
lost the 2nd key?
your post to a usa forum that has no such engine here.
so... answers will be mostly generic.
the key logo icon lamp means in English the immobilizer is active
Immobilizing the engine (our cars it cuts fuel)
the lamp never lies to you,
that is a fact.
it's a feature. (that cant just be removed for fun/or need)
if no second key?, (came with car new)
then you must guess
or like we do scan it.
the scan tool may show.
here in usa, can't speak for your country!
our laws, dictate that the ecu , cluster and Bcm and SKIS
are all married.
including the odometer,
and worse...
if you try go get cute and like take the wifes PCM
and put in your car, you brick both PCMs. (now 2 dead cars)
by law here. (non trival any of that)
this all stops the thieves dead in their tracks.
unless they arrive with a box full of matching computers.
all for you car , your engine and year. (matched and married)
(impossible sure)
ours
http://jeepdied.com/SKIM.html
see lamp 12. that must be cured FIRST. !
get a scan tool and use it
they cost $100 here, dirt cheap
or about 1hr shop labor. so , is free if it solves 1 problem.
see ?(pays dividends)
286 views
Usually answered in minutes!
×