Have electric trunk release but disconnect wire to take to body shop but when I closed lid forgot to reconnect wire , any ideas how to get in it, many thanks
Why don't you just use the key . If you do not have one then take it to the dealer get your vin number scan and get a key . I have owned 25 towncars and never been able to see someone get in that way. You can take one rear speaker out cut biiger hole and get in the trunk then what the reales stile only work with power
SOURCE: no heat in my 1996 lincoln town car
Then it is Possible Installers Utilized Wires from Hvac system for remote start and it may be Interrupting AMPERAGE with Temp Blend doors ? if not Try a Higher rated Thermostat such as 195 degree ratting.
SOURCE: Trunk wont pull shut.
You have a pull down switch that activates the pull down motor for the trunk lid to close. The manufacture of this part supplies this to Ford & General Motors vehicles. You can go to a Cadillac dealership & purchase this part far cheaper than at Ford. I use to work at a GM dearlership & my neighboring Ford dealer would order this part from me for the cost of mine where less than the cost from Ford. Figure those guys out at Ford. No wonder they don't need a goverment bailout
Frank
SOURCE: Chevy Impala 2007 trunk lid release
Fold down rear seat and climb in the trunk....there is a manual release at the center of the trunk lid. (mandated by the government to kids don't get trapped in the trunk).
SOURCE: 1996 Lincoln Town Car trunk motor won't shut off
under the trunk lip (directly where the latch goes into the lock jaws; remove the carpet so that you can see the side of the trunk latch; on the latch jaws (bottom) is a switch that contacts the latch (top) this switch is broken or, mis-aligned it opens (stops the trunk motor) when the latch contacts it.
Testimonial: "Thanks much for your speedy and knowledgeable reply."
SOURCE: I went to open my 2005 Toyota Corolla trunk using
If you have rear seats that fold down you can access the latch mechanism from the left side rear seat....if you are flexible. pull the corner of the seat forward to allow your arm to slide in behind. about 14-16" in, feeling up inside the trunk you can feel 3 quarter size holes in the sheet metal. The second hole has the cable release arm. stick your finger up there are pull towards you. this will release the seat allowing it to fold down. Crawl into the trunk. there is a glow in the dark release handle on the inside of the trunk lid to open the trunk. Note, these are instructions for an '04 corolla but I think it should work
494 views
Usually answered in minutes!
×