You need a LOCKSMITH THAT WAS NOT THE PAID AD ON GOOGLE. lots of bad players or untrained noobs in there.
The remote you bought online may be no good, wrong firmware, etc. Battery may be dead or weak
A good locksmith will determine what it is. Of course the VEHICLE must be working correctly, too.
try findalocksmith.com to find a background checked, legit locksmith who will take good care of you.
If near Boulder, Colorado... I will provide the diagnostics for free just for you
Why are you answering a post from Jul 31, 2018
×
If you have auto start will need dealer to program them
I would start by making sure you purchased the correct key fob for your vehicle. The best way to do this is to call your local dealership, ask for service, then ask what your key fob part number is. They will ask you for your vin# so have the handy. You can also buy a Dodge Durango Key Fob Replacement here.
You need the dealer to look into this.
SOURCE: 2005 dodge durango key fob
Hello and thank you for choosing fixya.com. I would suggest taking your vehicle to a local auto parts store and request to have a diagnosis done. (while auto stores vary, this is usually a free service and only takes a couple minutes to complete) to see if any codes are brought up. If so, the representative can tell you what the codes mean, and what needs replaced or repaired. Let them know of the situation. Even if no codes show up, ask them to clear the codes. If this does not work, do the following. 1: make sure that the batter in your key fob is inserted correctly, and that it is the correct size and type. 2. Disconnect the + Positive cable on your battery. This will reset your the vehicles computer. Maybe this will allow the vechile to code up with the fob. If not, I would take it to dealership, or backto an auto part store for further assitance.
I thank greatly for choosing fixya.com. I hope this information is useful to you and helps you get your fob working again. Let me know if you need further assistance, or have any questions or comments. Feel free to rate this information at your earliest convenience.
SOURCE: How do I program S Type Jaguar key fob Year 2000 Jag ?
Seperate key fobs only can be programmed in the following way.
Turn ignition on/off 8 x times (allow all functions to stabilise) after the 9th on - press a button on both remote fobs. then turn ign. off. use good remote to lock and then try new remote to unlock/lock. sometimes it works first time - sometimes you have to repeat actions. good luck.
SOURCE: programing new key fob fo 1998 dodge durango?
To program your vehicle's key fob you will need a scan tool. Select PROGRAM RKE on the scan tool and follow the instructions on the scan tool screen.
SOURCE: remote key fob won'tprogram
1-insert and remove key from ignition two times
2-close and open driver door two times
3-insert and remove key once from ign.
4-close and open drvr door twice
5-insert key into ign.,then close driver door
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle
confirming program.continue to do other remotes you have,steps 8 and
9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
422 views
Usually answered in minutes!
×