Where is the blower motor located on a 2006 Hyundai Tuscon?

SOURCE: Blower Motor

It's in the engine compartment on the passengers' side on the firewall.

SOURCE: locating heater blower motor resistor

the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.

SOURCE: does one have to change

Scheduled Maintenance Services, for most Cars, has to be done at 30K, 60K, and 90K. Hyundai dealer recommend to replace the timing belt at 60K Service.
If you wait, one of two things could happen: Nothing, or the belt could break and you would be out thousands to repair the engine instead of a $400 hundred to replace just the belt. If it breaks, there will be damage done to the valves and various other internal components, which will not covered under warranty. The problem is that the Dealer would charge you between $700-$800 because they would also replace the water pump at the same time. Or you can buy the timing belt and change it by your self. To do so, you nee the Haynes Repair Manual specific for your car another equivalent.
2006 HYUNDAI TUCSON GLS 2.7L 2656cc V6 FI (D) DOHC : Engine : Timing Belt

SOURCE: How do I remove the back bumper from a 2006

take help of the following steps to remove rear bumper on ur tucson.

Open the trunk of your vehicle.

1. Unscrew all the screws on the inside plastic trim that covers your bumper to trunk connection.
   
2. Pry the plastic piece out with a flathead screwdriver. You will expose the bolts that attach the rear bumper to the trunk.
   
3. Unscrew the bolts connecting to the inside of your rear bumper. There should be four bolts.
   
4. Unscrew the two to four screws connecting to your bumper from the inside of the rear wheel tire wells. These screws are on the area of the tire well that is closet to the bumper.
   
5. Slide under the rear of your car. Use a flathead screwdriver to pop the plastic rivets out of place along the underside of the rear bumper. There should be four to six rivets.
   
6. 
   Squat behind your car and firmly pull the bumper off. There will popping plastic sounds, this is the pop-in-place plastic rivets that are the last pieces that hold your rear bumper in place.
   

Jeffrey Turcotte

• 8991 Answers
• Posted on Feb 25, 2011

SOURCE: My 2008 Hyundai Tuscon "check

Please see my tip at http://www.fixya.com/cars/r5932051-check_engine_light_check. These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.