Question about 1996 Toyota Camry

1 Answer

Will messed up vacuum lines make car not start on 1996 camery

Posted by Bria Goodman-Tuley on


1 Answer


  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 139 Answers


Posted on Mar 04, 2019


1 Related Answer



  • 22 Answers

SOURCE: 1996 dodge ram 3500 5.9 diesel. wont engage 4 wheel drive. messed with vacuum line and it started bought new lines replaced them . now it don't work at all.can the control switch be

It's usually the CAD actuator as already mentioned. If that's not it, the last thing to check is the switch on the transfer case. Sometimes those will fail as well.

Posted on Jan 08, 2015


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

1996 dodge ram 3500 5.9 diesel. wont engage 4 wheel drive. messed with vacuum line and it started bought new lines replaced them . now it don't work at all.can the control switch be

If you are getting vacuum I would check the CAD (Center axle disconnect). You may want to go to a posi-Lok cable actuator if you're going to replace the vacuum actuator, better performance and you know it's going to engage!

Jan 07, 2015 | 1996 Dodge Ram 3500 Club Cab

1 Answer

Whats the firing order on a 1997 toyota camery 2200 4 cy

Hi Steph ! Since is a 4 (FOUR ) cylinder engine the firing order is 1342.

Mar 18, 2014 | 1996 Toyota Camry

1 Answer

Starts cold wont start when warm. I have changed the coil, plugs, wires, distributer, rotor, and ignition module. the idle also messed up at the same time, its idling high enough to spin the tires at a...

now is the time to start checking for vacuum leaks. I just fixed a 96 F-150 today with a cracked intake manifold. Look at all of your vacuum lines under the hood, that may include lines to the vacuum booster, the pcv valve, the egr valve, the air box, and in rare cases, even the battery box. If you can't find any leaks there, get a can of ether, start the truck, and spray it at the points where the intake meets the heads. If the RPM revs high or dips really low, you have a leak either in the manifold itself (like a crack) or the gasket has failed and it's time for a new one. I hope this helps.

Jan 06, 2011 | 1996 Ford F150 Regular Cab

1 Answer

Oseneck99 toyota camery got a po401 code i replaced egr valve and egr pressure sensor. now i have codes po441 po446 please help.

Recheck all the vacuum lines near the EGR solenoid. The new codes are for the EVAP emissions system. they are codes for incorrect purge flow. You may have left a vacuum line of, switched a couple of lines or forgot to plug something back in.

I’m happy to assist further over the phone at

Sep 30, 2010 | 1999 Toyota Camry

1 Answer

I can not find a dimmer switch for the dash lights for my 1996 toyota camery

on dash like a little wheel with lines on it fitted to some models

Feb 22, 2010 | 1992 Toyota Camry V6

1 Answer

1996 Ford Escort Engine Code 1441. Decrease in MPG. Rough idle.

check to see if your O2 sensors are ok. if they aren't replace em and go from there. it could also be a vacuum line that is messed up or cracked check any line u see and see if they are ok to.

Dec 27, 2009 | 1996 Ford Escort 4 Door

1 Answer

1996 toyota camery code po401

Clean the EGR air passage tube.

Carbon built up is worst inside this air passage tube.

You will need Seafoam or WD-40 and LOT OF TIME to clean out this tube.

A vacuum will help speed up the cleaning.

Please post more information on the comment window.

Aug 11, 2009 | 1996 Toyota Camry

4 Answers

1996 Camery P0401

the EGR valve is clogged on the backpressure port, that is the small tube that you need to clean the EGR valve needs to be replaced unless you are sure that air can pass through with the egr valve opened.
The engine light needs to be reset it does not automatically turn off. In some cases if the egr valve is known to be good as well as the modulator there may be a problem with the vacuum switching valve(VSV) that controls the egr system and this vsv may need to be replaced.

Jun 08, 2009 | 1996 Toyota Camry

1 Answer

1996 camery radio blew a fuse.location of fuse box and no.

There are 2 fuses that control the radio.

check the 20 amp DOME fuse and the 15 amp CIG/Radio fuses, in the fusebox under the dashboard.

Jan 14, 2009 | 1996 Toyota Camry

Not finding what you are looking for?
1996 Toyota Camry Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides