SOURCE: driver side power window stopped working
The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps
SOURCE: how do i remove the right rear door panel on a 04
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 99 Buick LeSabre, how do I remove driver side door panel to replace power window motor?
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: chrysler 2004 sebring manual
remove the hidden screws be hind mini covers, start from the bottom of panel with panel tool and pry the plastic retainers away from the door plate and remove the wire connectors form switches and replace the handle, reverse the order, GOOD LUCK, RDJRP
SOURCE: how to replace driver side mirror on a 2007 chrysler sebring ltd
Once you take of the door panel, you should have two or three nuts behind the black triangler shape cover..Once you take them off, you just reverse the procedure...To take the door panel off, you may need a flat head screwdriver, and a phillip screwdriver..You may have two or three screws to take off..One is by the door handle..One may be under the window switch..which you can pop that off with the flat head screwdriver...Then just pop the panel off, and disconnect all the connections..Should be no more than 3....Goodluck..
Testimonial: "Just what a needed, straight to the point."
168 views
Usually answered in minutes!
×